0
\$\begingroup\$

I have an LED control panel that uses the MIC5891 driver. I measured the VBB load voltage at 9.05 V, however, the outputs (1 through 8) all register at 1.96 V. What could be controlling this output voltage? What changes can I make to the inputs to increase the output voltage to 3.0 V?

\$\endgroup\$
2
  • 1
    \$\begingroup\$ Welcome! Schematic please. \$\endgroup\$
    – winny
    Aug 7, 2022 at 17:02
  • 1
    \$\begingroup\$ Did you connect the LEDs without current limit resistor in series? \$\endgroup\$
    – Jens
    Aug 7, 2022 at 17:17

0

Reset to default

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Browse other questions tagged or ask your own question.