I want to display a 4 digit number on a small device that fits in a hand. I have a CR2032 3V battery at around 230mA, my microprocessor is a 8051 (in a BLE112) usually uses about 0.9µA and I want the device to last as long as possible.

I've looked at the typical seven segment displays, which typically uses a few mA which is too much.

A alternative is the Sharp LS013B7DH01 which is used in Pebble and uses 5 µA, but seems a bit complex for my microprocessor (and expensive)?

There should be some simple low power 7 segment display which has a average power consumption measured in µA (not mA), but I simply can't find it or think of some other solution.

What alternatives do I have?

  • \$\begingroup\$ How often does the value change? \$\endgroup\$ – Ignacio Vazquez-Abrams Oct 11 '13 at 9:20
  • \$\begingroup\$ When in use, a few times per minute \$\endgroup\$ – Hink Oct 11 '13 at 9:37

LCD display without back-light is the only possible solution on these conditions.

Something like this:

enter image description here

Here is some example data sheet: Link to PDF

  • \$\begingroup\$ Nice, how much energy would it use? \$\endgroup\$ – Hink Oct 11 '13 at 9:36
  • 1
    \$\begingroup\$ @Hink - probably several uA. \$\endgroup\$ – johnfound Oct 11 '13 at 9:37
  • \$\begingroup\$ How would I drive it with a 3V (DC) coincell battery in a power efficient way? I found out that I need some separate driver chip which can alternate the current. Preferably I would like to just input numbers via SPI, I2C etc. \$\endgroup\$ – Hink Oct 22 '13 at 16:22
  • 1
    \$\begingroup\$ @Hink - but you can generate AC with the outputs of the uC. But IMO, how to do so is a little bit offtopic in this answer. Maybe you have to ask another question about how to control LCD display. \$\endgroup\$ – johnfound Oct 22 '13 at 17:12
  • 1
    \$\begingroup\$ Note that you need a minimum of 1 + (7 * 4) = 29 outputs to drive a static 7-segment 4-digit display (no decimal points or colon) as in the linked datasheet. One output drives the backplane (common) plus you need one for each segment. \$\endgroup\$ – Spehro Pefhany Oct 23 '14 at 20:49

E-paper displays "stick" at the last value displayed, and only use power to change: http://www.eink.com/

They're a bit of a hassle to drive, and expensive.


Sarkfun used to sell a small E-paper display. https://www.sparkfun.com/products/retired/10150

Perhaps you can locate a different widget vendor for the same.


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.