2
\$\begingroup\$

I have three small motors, and I know you should use a motor shield or driver when working with the arduino, but would it be safe to use these with the arduino by themselves without a shield? And if so, what would be the best way to work with them and control their speed? the motors

\$\endgroup\$

2 Answers 2

3
\$\begingroup\$

You will damage the Arduino chip if you connect a motor directly to one of the outputs. I've used the Adafruit motor shield with motors like that.

\$\endgroup\$
4
  • \$\begingroup\$ Ok, it's weird though, I bought an arduino kit and it came with the motors, but did not provide a motor shield. It is safe to run a servo without a shield though, correct? \$\endgroup\$ Feb 3, 2011 at 17:11
  • 1
    \$\begingroup\$ If your kit came with a transistor - electronics.stackexchange.com/questions/7235/… \$\endgroup\$ Feb 3, 2011 at 17:18
  • \$\begingroup\$ Yes it did. I guess that explains it. \$\endgroup\$ Feb 3, 2011 at 17:19
  • 1
    \$\begingroup\$ Although I use H-Bridges nowadays, when I first started, I plugged brushed motors in directly to outputs and it didn't damage anything as far as I can tell. This was a few years back and it's the only arduino I have. I think these ATmegas are pretty dang tough. \$\endgroup\$ Feb 4, 2011 at 1:44
1
\$\begingroup\$

Not possible...

The Arduino can not drive that type of motor - the start up surge would damage the chip, also a diode is needed to handle the 'back emf' when the motor is turned off.

A servo has internal electronics to switch the motor. you just provide a repeating pulse of the correct length.

\$\endgroup\$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.