The Stack Overflow podcast is back! Listen to an interview with our new CEO.

Questions tagged [at-commands]

AT commands are used to control MODEMs, such as GSM/GPRS/bluetooth modules.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
0answers
31 views

How do you get the call ringing response after sending ATD from gsm module?

I have a gsm module. I want to know which AT command can tell me if the target phone is ringing or not. I want to count time between start of ringing and user response Example: atd12345 ...
1
vote
0answers
391 views

Error sending SMS to SIM900 in PIC

I am trying to interface SIM900 with PIC18F2520. I need to send SMS to a particular cell number. According to AT commands, ...
0
votes
0answers
19 views

sim800 - TCP GPRS slow socket opening

I'm trying to create an internet interface for my AVR project using a SIM800 module, which I use to open a socket to my server. My only problem is that bringing up TCP takes lots of time. The other ...
0
votes
0answers
44 views

STM32L496 - AT Commands

I initially had complete connection with the STM32L496 Discovery board (with STMod+) and my laptop through Tera Term and was configuring it to only use the NB1 network. This was successful and the ...
0
votes
1answer
26 views

Bluetooth HC-05 AT Commands

I'm attempting to put an HC-05 module into command mode in order to change the PIN and default baud rate etc. According to the datasheet, PIO11 needs to be high to do this, so I connect it to 3.3v, ...
0
votes
0answers
150 views

How does GSM Module store incoming SMS in its “SM” or “ME” memory?

I am using AI Thinker A7 GSM/GPRS/GPS Module demo v7.1.(The Rx, TX, GND pins of this module are connected to tx, rx, gnd pins of the prolific Rs232-TTL converter and a virtual com port is open in ...
0
votes
1answer
98 views

SIMCom SIM808 SD card problem

I am working with SIMCom's SIM808 2G+GPS modem and trying to connect it to an SD card. I am following SIMCom hardware design docs, to save some data in SD memory. The problem is: when I send ...
0
votes
0answers
673 views

Enabling SD card access on SIM808

I am currently working with SIMCom's SIM808 2G+GPS modem. In my setup, an MCU communicates with the modem over UART to save some data in the SIM808's filesystem. As the modem's built-in memory is < ...
0
votes
0answers
279 views

Problem in connecting to a server waiting for a TCP request using ESP8266

I'm using ESP8266 for connecting to a appspot-preview.l.google.com server which listens for TCP request and answers back a number (it's for training purposes). ...
0
votes
1answer
854 views

SIM800L - No response while sending AT commands

I'm new to this arduino world. I'm trying to communicate with my arduino nano and SIM800L. I read few things in the internet and found a basic code. I tried copying it and tried to work it out, but I'...