All Questions
Tagged with atmel-studio spi
5 questions
1
vote
4
answers
658
views
Atmel SPI "wait for transmission complete" example is wrong?
I am configuring my first SPI transmission on my atmega328p.
Everything seems right (My SPI interrupt ISR(SPI_STC_vect) fires when transmission is done, and I can see all SPI pins on the oscilloscope ...
- 3,620
1
vote
1
answer
188
views
Using Data Visualizer with Atmel-ICE with SPI physical interface
I am trying to output some debug strings from an ATmega328P to a terminal window on Atmel Studio using the DGI. I would like to use the 6-pin 100-mil connector of my Atmel-ICE Basic Kit, which I ...
- 319
1
vote
2
answers
2k
views
Cannot enter programming mode ATMega328p
I'm using an ATMega328p Xplained Mini development board. I was able to program it using Atmel Studio 7, being new to AVR programming I accidentally set the RSTDISBL fuse to 0 (has a default value of 1)...
1
vote
2
answers
12k
views
How can I set up SPI using Atmel Studio and C code for ARM processor?
I am trying to program the SAM3x8E chip on the Arduino Due through Atmel Studio. I would like to be able to control a digital resistor over the SPI interface with the SAM3 chip. I am running Atmel ...
- 327
0
votes
1
answer
2k
views
How to configure the SPI pins(MOSI,MISO,sclk and SS) for ATMEL ATSAM3X8E?
I am using ATMEL studio 6 for programming and novice in embedded systems.At present, I have read the theory working of SPI. I understand that I have to set particular bits to one in the control ...
- 377