Questions tagged [balancing]

The tag has no usage guidance.

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
0answers
68 views

How can I balance 2 separate LiFePo4 batteries?

On my boat I've got devices that run on 24V and others that run on 12V. Seeing as how the alternator, wind generator and solar panels are all generating 24V, I guess it's fair to say that this is ...
1
vote
1answer
46 views

Can this scheme be used to balance an unbalanced output transducer?

If we want to create fully differential and balanced outputs, and if we don’t have a single ended to differential ended converter/driver, can we use the following scheme neglecting the voltage divider ...
1
vote
1answer
70 views

LTC4370 load sharing

Datasheet LTC4370 Background: I want to use this chip to combine the power output of two 2.4A USB ports on a USB power bank I have. If this is possible it will output ~25W and w/ my dc-dc converter ...
0
votes
2answers
62 views

How to convert this single ended output to a precise impedance balanced output?

This amplifier suits my purpose with one matter that I couldn’t figure out. Its output impedance is given as 0.01 Ohm. The output of this amplifier will be coupled to a very high input impedance(more ...
0
votes
0answers
47 views

Does the location matter when performing unbalanced to balanced source conversion for this scenario?

Below circuit shows the issue when the output impedance of a DC-like source V is not balanced when coupled to a Diff Input(differential input of a data-acquisition board). As you see as an example for ...
0
votes
0answers
83 views

Ceramic capacitors in series to increase AC voltage rating

If I put 4 of 1uFx100V cercaps in series I will virtually have one .25uFx400V capacitor. As I know I should use balancing resistors for even distributinon of the voltage across the capacitors. ...
0
votes
0answers
188 views

How do I make a simple bidirectional current limiter

I want to connect two separate batteries together and let the highest voltage one charge the lower one not exceeding the desired current. I expect it to be a solid state solution without the need for ...
0
votes
0answers
172 views

How can 8.4V stacked super-capacitors (EDLC) not require balancing?

I've recently seen 8.4V stacked super-capacitors which advertise themselves as "not requiring any balancing". Namely, the 196HVC series from Vishay. How can this be true? Even if the cells are ...
0
votes
1answer
458 views

Quadcopter balance with MPU-6050

It is not uncommon to see people asking about how to balance a quadricopter using MPU-6050. It's also common to see people answering that a PID controller is needed. However, people doesn't say how. ...