Episode #125 of the Stack Overflow podcast is here. We talk Tilde Club and mechanical keyboards. Listen now

Questions tagged [band-pass]

Bandpass is an adjective that describes a type of filter or filtering process; it is to be distinguished from passband, which refers to the actual portion of affected spectrum. Hence, one might say "A dual bandpass filter has two passbands." A bandpass signal is a signal containing a band of frequencies not adjacent to zero frequency, such as a signal that comes out of a bandpass filter.

Filter by
Sorted by
Tagged with
0
votes
1answer
251 views

How to calculate the gain of a RLC tank filter?

I'm supposed to create a passive bandpass filter to select a reasonably sinusoidal 750 Hz signal from a 250 Hz square wave. Since we have very limited choices for the inductor (0.03 H) and capacitor ...
0
votes
2answers
872 views

How to find Vout for the following band pass filter

I have a problem finding the following Vout for this circuit. Is it possible to just use the following formulas that i have shown. I am just unsure due to the resistors. I assume that what i have ...
2
votes
4answers
7k views

Why is center frequency of a bandpass filter is given by the geometric average of the two cutoff frequencies?

In electronic communication systems, there is a concept called center frequency. A bandpass filter has upper cutoff and lower cutoff frequencies. Center frequency supposed to be in the middle of these....
0
votes
2answers
277 views

Op-Amp Input Bias Compensation for Multiple Feedback Filter

I'm adding an input bias current compensation network to the positive op-amp input of my band-pass multiple-feedback filter. I'm setting the source impedance for the positive input pin equal to that ...
0
votes
1answer
96 views

Digitally selectable filter

I have asked a similar question but I did not get an answer, as it was too specific. So I will build on it but make it a bit more broad spectrum. I would like to make a digitally selectable BPF using ...
0
votes
1answer
93 views

Cascaded Filter Output Not Correct

I am simulating a speaker system with tweeter, woofer, and midrange speakers. I know my values for the components are all correct, but the output plot is a little off. The passbands should be a little ...
0
votes
1answer
1k views

Deriving Bandpass Transfer Function

I'm designing a bandpass filter and have been doing some reading on it. I found a transfer function describing the circuit (which apparently all formulas describing this circuit are derived from): $$...