Questions tagged [base]

A BJT (bipolar transistor) has three leads: base, collector and emitter. In most cases base is used to control the transistor.

5 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
104 views

How to select a diode for baker clamp?

What are the requirements when selecting a diode for baker clamp circuit? 1- for example, How the reverse leaking current of the diode affects the circuit? can a diode with relatively high reverse ...
1
vote
0answers
89 views

Why is a voltage across emitter and base required in a bipolar transistor?

I read the reply to this question but I cannot really make sense of it: In an NPN transistor, why doesn't current flow without applying a base voltage? if I have a npn-transistor and and apply a ...
0
votes
0answers
28 views

Where to find details of dimensions and doping of a typical bjt

I have been searching for dimensions and doping levels of base, emitter and collector for a typical bipolar junction transistor presently in use. I have tried searching on internet and seen datasheets ...
0
votes
0answers
48 views

Finding the voltage of base Vb

I wanted to know if Vb in the trasistor in the photo is equal to the formula in red circle: Vb=R2*Vcc/(R1+R2)
0
votes
1answer
55 views

Base resistor configurations, are there any differences?

Sorry for the noob question. From my understanding, R1s acts as pull down resistors for the base and R2 will limit the current flow to the base. I have seen both configurations, but couldn't work out ...