Questions tagged [bit-rate]

Questions relating to the rate at which bits are transmitted over a channel (wired or wireless). Usually specified in bits/s or a multiple of that unit. Related but not the same as baud rate or symbol rate.

1
vote
2answers
263 views

8051 baud rate calculator using 16-bit timer for software UART timing

I'm making a project in which pulsed laser beam data is sensed through many optical sensors (one sensor per port pin), so essentially, I'm going to be making 4 UARTs to sense this. Currently I am ...
0
votes
2answers
49 views

Connecting mixed-speed multiple serial devices to two microcontrollers

I'm trying to figure out the best way to integrate all devices flawlessly on the 8051 based microcontrollers. If each device was the same low speed, then I could multiplex each and every one of them ...
0
votes
2answers
179 views

How does widening the frequency band allows us to make faster pulses in a radio link?

I’m new to radio communication and completely ignorant in the topic. I spent some time writing software which includes calculation of the channel capacity (in bits/second or symbols/second or bauds) ...
1
vote
1answer
301 views

Is there a fieldbus with more than 250 nodes per segment?

We plan to realize a sensor cable several 1000m long which has ideally every 1-2m a magnetic field sensor on a small 10x30mm platine with microprocessor/FPGA for DSP and I2C on chip communication. ...
0
votes
1answer
38 views

measuring the BER for various input data rate over a custom made channel

I have a wireless channel, for which I need to pass binary bits and input and measure the BER at the output. The problem for me here is varying the data rate at the input. How can I represent the ...
-3
votes
1answer
47 views

Bandwidth (Data rate) of a laser beam when no datasheet exists for the module

I ordered a large number of laser modules that look like the following: When inspecting mine with a basic multimeter, I noticed a 90 ohm smd resistor is fitted on the module. I see no other ...
1
vote
0answers
195 views

Half-duplex Bit-Banged Port for 8051 microcontrollers too slow?

I was looking at: https://www.maximintegrated.com/en/app-notes/index.mvp/id/3524 and it claims that one can achieve over 2mbps on a 32Mhz clock when bit-banging with an 8051. That means 1mbps on 16Mhz....
0
votes
0answers
20 views

Data rate with modulation and conventional encoding

I had a rather simple question. Say I had a SISO communications system with an information data rate of 50 Mbps that uses QPSK modulation and a rate 1/2 conventional coding. What would be my symbol ...
0
votes
0answers
20 views

sampling rate and bit resolution for Scanning Probe Microscopy

I am trying to compare two products and see which one offers higher performance in terms of sampling rate and bit resolution. Below are the specs I was able to gather from product1 and product 2. (...
0
votes
0answers
20 views

Determing proper wireless parameters for HMTRP radio module

I'm trying to properly setup an HM-TRP FSK radio module to send and receive data the best it can at 56kbps. I think I'm wrong with setting it up to use 600Khz "receive bandwidth" and 160Khz "modulate ...
0
votes
0answers
58 views

Serial baud calculation without using serial interrupt - 8051

Here's the situation. I have a project which utilizes multiple sensors and connects to another unit through standard UART (8N1). Because no data needs to be missed from any device, I made the ...
0
votes
0answers
697 views

How to calculate bit time of any signal?

Given a data rate or clock rate, how to calculate bit time of any signal/interface? As per what I know, bit time = 1/data rate. Is it correct? I got a little confused when I could not calculate the ...
0
votes
0answers
1k views

Using HC05 Bluetooth SerialPort to stream music/voice via Arduino

I'm considering streaming music/voice over Bluetooth serial link (via HC05) from PC to Arduino. By doing this, there would be no need for a SD card. Here is the questions I have. Any help is ...