Stack Exchange Network

Stack Exchange network consists of 174 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [bus-pirate]

The tag has no usage guidance.

0
votes
0answers
36 views

Hacking an eight cell battery monitor

My goal is to monitor each cell voltage of a seven cell li-ion battery and send this to a Linux board, specifically the Jetson TX2, over i2c. There does not seem to be any off the shelf component that ...
0
votes
0answers
46 views

Read data from MB85RS2MT using bus pirate

edit: I guess I'm targeting the wrong chip in the first place... FRAM chips doesn't seemed to be storing firmware. But I'm still willing to learn more about the question I asked. Original post: Hi! ...
0
votes
1answer
64 views

How to prevent SOIC8 clip from backfeeding

I'm trying to read the flash ROM using a SOIC8 clip, on board. I am horrible at surface mount soldering. Is there a way to use the clip on the board, without removing the chip, and not have the SOIC8 &...
0
votes
0answers
259 views

Bus Pirate Flashrom OTP chip issue (Winbond W25Q128FV SPI flash)

So I have an embedded device with a Winbond W25Q128FV SPI flash chip on it and I am trying to extract the firmware by dumping the flash memory. So far I have used a Bus Pirate with Flashrom to do so. ...
0
votes
0answers
128 views

Trying to get UART TX to work

I am trying to reverse engineer a console port for a network device. The console is using UART (figured out from a logic analyzer). I hooked up the console to a bus pirate and set up the baud-rate and ...
0
votes
1answer
104 views

Reading 4Mbit SPI flash memory

I am trying to use the bus pirate to read the ESMT F25L004A flash chip, looking at the datasheet here. http://www.esmt.com.tw/db/manager/upload/f25l004.pdf I see that the documentation says the opt ...