All Questions
Tagged with capacitive pcb-design
4 questions with no upvoted or accepted answers
2
votes
1
answer
140
views
Capacitive Touch Pad Design with TTP224 ic
I am designing circular capacitive touch pads of Dia:20mm driving from TTP224 IC on my PCB. There will be 2mm glass panel above Touch pads. My PCB contains other circuits like Arduino, Antenna bands ...
1
vote
0
answers
120
views
Correct design of capsense controls
I am trying to design a PCB with some capacitive controls. My first iteration did not seem to work well:
This was a 2-layer 1.6mm board with one circular control, and 5 buttons. The board is 48mm ...
- 27.6k
1
vote
0
answers
380
views
Ground mesh under the capacitive touch pad
I am going replicate a circuit basing from adafruit AT42QT10xx, I will be using the AT42QT1010 variant.
The touch pad is the blue pad bottom layer, but there is this mesh on the top layer after i ...
- 2,004
0
votes
1
answer
103
views
How to simulate a finger touch electrically to remove noise
I am working on a project with "SIM800L" GSM module, the problem is that there is a noise from the module in the calls and it disappears when I touch the module's body with my hand.
Kindly, ...
