Skip to main content

All Questions

Filter by
Sorted by
Tagged with
0 votes
1 answer
68 views

resistor placement in inverting amplifier to minimise noise coupling

(Image is my own creation.) I notice that an inverting amplifier can be very sensitive to capacitive and inductive noise coupling on a PCB. I was wondering whether the placement of the R1 resistor ...
one_three_three_seven's user avatar
2 votes
1 answer
82 views

Current slew rate specification of op-amps?

I know that slew rate specifies how fast the output voltage of an op-amp can change. But is there a measure that specifies how fast the output current of op-amps can change? I need this information ...
Mustafa Turhan's user avatar
0 votes
2 answers
115 views

Does max OP Amp Capacitive Drive Capability Matter with Active Filter?

I know that every OP Amp does have a limited capacitive load drive capability. Even if not specified, it is always a good practice to use a series isolation resistor. Anyway; when looking at an active ...
huababua's user avatar
  • 125
0 votes
1 answer
1k views

How to know if an opamp can drive capacitive loads?

There has been a lot of questions about how to stablise opamp circuits driving capacitive loads. However, I know there are some op amps that are designed to drive capacitive loads but I am struggling ...
yolt's user avatar
  • 113
0 votes
1 answer
236 views

How to properly drive parallel analog switches (variable capacitive loads) with opamp(s)?

So as you can see I have 16 SPDT switches on one side of my 16 'RUT paths' and 16 SPDTs on the other side. Each SPDT(ADG1434) has two source pins (SXA and SXB) and a common drain pin (DX), 'X' ...
paulplusx's user avatar
  • 314
-1 votes
2 answers
180 views

How to make sure that my compensated attenuator would work for certain pulse widths?

I have an input (one-shot) pulse that has to be attenuated by 1/2 (half). The input pulse would be of variable width in between 1us and 100ms and would have a variable amplitude: one voltage level ...
paulplusx's user avatar
  • 314
1 vote
3 answers
565 views

Stability - Driving a Capacitive Load

I know I have been asked not to provide video links and ask questions. But I have no proper guide/mentor or anyone who can provide me better answers other than users in this site. So, please pardon ...
user avatar
3 votes
4 answers
5k views

Capacitance on the output of an op amp

I have read a lot about capacitive loads on the output of an op-amp and the possibility of unwanted oscillations and instability. my knowledge on phase margin and frequency domain analysis is a little ...
sadegh satari's user avatar