All Questions
Tagged with circuit-analysis sensing
4 questions
2
votes
2
answers
223
views
Modifying a TDS Module for Higher Electrical Conductivity Measurements
I recently acquired a Keyestudio V1.0 TDS module, primarily used for measuring the electrical conductivity of water. The module is recommended for 0-1000ppm or 0-2000μS/cm measurements.
However, my ...
1
vote
2
answers
211
views
**FINAL UPDATE** I'm getting closer to a workable circuit for this device?
FINAL UPDATE
I think the power supply is squared away accept for some caps and resistors. Thank you for sticking with me. One question:
There are two thermistors (one for each battery pack) that are ...
3
votes
0
answers
146
views
How does this capacitance measurement op-amp circuit work?
I'm studying this scientific paper where a capacitance measurement is done with the circuit shown at page 3. For simplicity I reported it here:
A sinusoidal signal is applied at the input through a ...
0
votes
2
answers
194
views
Why I got a minus output value?
When I simulate the circuit on (OrCad) I got an output voltage between (0 to 1) V changing with temperature .
but when I connect the circuit I got the output voltage = -1.85 in minus and different ...