All Questions
Tagged with compensation buck
8 questions
1
vote
1
answer
188
views
LTC7803 Buck Converter Current Mode Compensation
I wanted to design a step-down converter using the LTC7803. Goal is to have a 5V, 0-2A output with an input voltage range of 10-30V. Switching frequency is set at 1MHz. As shown in the LTSpice picture ...
- 101
1
vote
0
answers
155
views
Battery charger circuit confusion - drive and compensation
I'm building something that is going to have Li-Ion batteries so I'm trying to learn how a battery charger actually works. I've been looking over the datasheets for the BQ2000 and the BQ2954. I will ...
- 349
4
votes
1
answer
159
views
Output voltage not stable - What is compensation with respect to DC-DC (buck converter)?
EDITS:
Input voltage range: 24V to 48V.
Changing the load current from 0.38A to 1.018A increases the mean output voltage from 12.779V to 13.26V. The supply should be producing 12.5V.
I'm using this ...
user220456
0
votes
2
answers
335
views
Tricking feedback of a buck converter
I need to trick the buck converter feedback. The converter that I am going to use is TPS40192DRCT.
Instead of the regular resistor divider, I want to feed there voltage proportional to current ...
- 1,395
0
votes
0
answers
621
views
Using UC3844 and TL431 to compensate a forward converter
I am designing a forward converter capable of providing 5A at 30V at the output. For the compensation part, I am thinking to use UC3844 in combination with TL431 to achieve peak current mode control.
...
- 180
0
votes
1
answer
107
views
Feedback loop design (buck converter): Output capacitance- effective value or nominal value to be considered?
In this TI datasheet of TPS62180, it was mentioned that the LC filter combination should be selected from a set of predefined values. I understand this is usually the case for an internally ...
- 3,156
2
votes
1
answer
2k
views
Loop compensation of a Buck Converter
I have a buck converter. TPS54260
Vin = 7V-20V
Vout = 5V
Iload=600mA.
I realise that there is a similar question in this forum but I was not able to get clarity.
I want to understand what do you ...
user220456
6
votes
1
answer
1k
views
Loop compensation design of buck converter
I am trying to design loop compensation with type-3 error amplifier for a buck converter. I'm a student and very inexperienced in this subject. Please bear with me.
Here is the general procedure ...
- 897