Questions tagged [configuration]

The tag has no usage guidance.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
2answers
94 views

NOR Flash - Max Frequency of Operation

I am wokring on a board that uses Micron 1Gb QSPI (mt25qu01gbbb8e12-0aat) to load configuration on to FPGA at power on. As per the datasheet of QSPI (https://www.micron.com/-/media/documents/...
2
votes
0answers
108 views

How is CC3000 placed in Simple Configuration mode?

I've ordered a CC3000MODR and soldered it to a simple breakout board. In the First Time Configuration it mentions a Simple Configuration mode: The CC3000 is placed in Simple Configuration mode and ...
1
vote
0answers
67 views

Multicontext FPGAs

I recently read some papers that mentioned multicontext FPGAs, which have several copies of every programming bit. This allows to download a bitstream to the board while the active context (the ...
0
votes
0answers
146 views

Which 18650 battery connection layout is best?

I am building a 5S6P battery with 18650 cells. I have limited space so the geometrical layout is constrained. I can think of 2 "optimal" ways to layout the cells connections but I don't know which is ...
0
votes
1answer
235 views

MPLABX with PIC18F4550 Debug and programming are not working

First I used MikroC for PIC to modify a firmware to a PIC18F4550. I was programming the device using MPLAB IPE and the PICKit3 programmer, everything was ok. Now, I need to change to MPLABX XC8 ...
0
votes
0answers
70 views

Pin strength configuration

Please, help me understand the specsheet on page 2-22. The table says that 3.3V standard supports 12mA drive strength, but there is also a "software" defined strength. What is it? There is also a "...
0
votes
0answers
33 views

Why is the order of these serial components changing the current flowing? (Keithley 236)

I have an electronics setup I'm using for research purposes. I'm having some strange behavior so I've tried to boil it down to the simplest working example. Most basically, a voltage is being applied ...
0
votes
0answers
58 views

Embedding python interpreter in the TM4c1294XL

I have a python file that I want to run on the board. Hence I want to embed the python interpreter (written in C) in the board. I managed to write separate C project that runs the Python file. It ...
0
votes
1answer
76 views

Is there an exponentiation configuration for MOSFETs or Opamps?

I am working on a problem that can be made really simple if the output of the transistor were to be a fixed power of the input. For ex., if the input is 8 V and power is 0.333, then the output voltage ...
-2
votes
2answers
346 views

usb to rs232 serial communication

I have to configure my rs232 to device(transmitter) using usb to serial communication. I have tried with usb to rs232 cable and connect the transmitter 6 pins to the db9 connector but it did not work. ...