Questions tagged [configuration]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
17
votes
6answers
5k views

Choosing Configuration Jumpers - Solder bridges, 0-ohm resistors, DIP switches, pin jumpers

I'm working on a development board, and need to let users set some configurations. It will be used by students and engineers who are trying to build circuits on a breadboard; I'm not dealing with ...
0
votes
1answer
83 views

Get more AS-attached flash chip information from ALTASMI

I am playing with the attaching various configuration flash devices to the Altera Cyclone 3. In particular, I want to replace EPCS16 (2MB) with W25Q128 (16MB) - for both size and cost reasons. Is ...
7
votes
3answers
1k views

What actually happens when we set direction on GPIOs in controllers ?

Generally, while working on GPIO pins of any controller/device, we set the directions for the GPIO pins. Let's say in LPC2148(ARM7 core) controller, we have IODIR to configure the direction of Pin. We ...
4
votes
1answer
4k views

Error when using debugging under Atollic TrueStudio / STM32

I'm using STM32F103C8T6 Atollic TrueStudio STLink2.1 Error I get when debugging: Debug configuration set in TrueStudio: What worked before was in SW4STM32/Eclipse, with the following settings. I ...
3
votes
2answers
1k views

4 Digit LED Display usage

I have a 4 digit LED display that I would like to integrate into my project, but only has 12 total pins when there are 4 digits. I am a beginner so I do not know how or which pins to power in order to ...
2
votes
3answers
2k views

Need help with hardware and software config on PIC12F675 to light up an LED

I'm trying to get an output from a PIC12F675, but I can't seem to get it to work. Here is my hardware setup that I breadboarded: And here is my code programmed using a PicKit2: ...
1
vote
2answers
7k views

Hall Sensor NJK-5002-C Configuraion

Here is the link to the sensor I am talking about. Now the problem is that according to the label it has as shown, it says that Brown wire goes to V+, Blue wire to V- and the Black wire goes to Signal....