Skip to main content

All Questions

Filter by
Sorted by
Tagged with
0 votes
1 answer
36 views

Makerbase TMC2226 stepper driver board: are current sense resistors underrated power-dissipation-wise?

I am looking at the schematics for Makerbase TMC2226 stepper driver board: The schematic shows 1/8W 0.11 ohm current sense resistors. The datasheet for TMC2226 IC says: 8 Selecting Sense Resistors .....
Alan E's user avatar
  • 101
2 votes
1 answer
47 views

Troubleshooting Voltage Sensing Issues in Buck-Boost Chip Simulations

I performed a simulation on a buck-boost chip (LT8390). I understand that the sensing resistor placed between LSP and LSN is supposed to sense the differential voltage. This voltage is then amplified ...
chami's user avatar
  • 534
0 votes
1 answer
58 views

Sensing Resistor in Buck-Boost controllers

In the LT8390, there are two sensing resistors. The one connected to LSN/LSP is called RSENSE(Buck), and the one connected to ISP/ISN is called RSENSE(BOOST). To illustrate this more clearly, I've ...
chami's user avatar
  • 534
0 votes
2 answers
360 views

Designing a current sensing op-amp circuit for an AC load

I'm trying to simulate a current sensing op-amp circuit. My AC voltage, 24 VAC, is across a load of 10 Ω. I used a 100 μΩ resistor and measured the voltage across it using an op-amp. Looking at some ...
Bilal's user avatar
  • 1
6 votes
1 answer
525 views

Is it wise to determine heating element temperature from resistivity?

Context I'm making an electric furnace for melting metal, and aiming to make my own controller. Everyone seems to just use thermocouples and a control loop, I thought perhaps I could just measure the ...
TrisT's user avatar
  • 355
1 vote
1 answer
201 views

How to select current sense resistors for ir2136 ITRIP signal

Looking at the datasheet of the IR2136 it suggests this little resistor network as input for the ITRIP pin. https://www.infineon.com/dgdl/Infineon-IR213-DS-v01_00-EN.pdf?fileId=...
Fabian's user avatar
  • 113
1 vote
2 answers
1k views

Four-terminal resistor pinout?

Anyone can tell me (or preferably, point me to a source that explicitly shows) the pinout of the 4-pin current-sense resistors? I'm seeing the datasheets for three different models (including Rideon'...
Cal-linux's user avatar
  • 2,175
1 vote
1 answer
439 views

What are shunts, as related to their use in current sensing in microcontrollers?

Within the manual for the I/O module I'm using (a Loytec LIOB-153) there are wiring diagrams to aid in wiring up your sensors and other inputs/outputs. There are two wiring diagrams for the purpose of ...
W1llums's user avatar
  • 23
5 votes
2 answers
960 views

The benefit to make or use a surface mount 4-terminal current sensing resistor

I find some precision SMD resistors are 4-terminal, like vishay's CSM3637P. It's constructed as below: It seems it only make a slot on each pad, then get two extra pad to do the voltage measurement. ...
diverger's user avatar
  • 5,886