The Stack Overflow podcast is back! Listen to an interview with our new CEO.

Questions tagged [design-rules]

Design Rule Checking (DRC) is the area of Electronic Design that determines whether the physical layout of a particular (PCB) layout satisfies a series of recommended parameters called Design Rules.

2 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
0
votes
0answers
45 views

I2C line pulled low by MCP23017

A simple interface of MCP23017 with Rpi using I2C lines. Since there is already an internal pull-up resistor of 1.8k on rpi I didn't use any pull-ups n I2C lines. Running ...
0
votes
1answer
418 views

Altium avoiding a collision check

I'm trying to create a rule to ignore a collision between some pads on the top layer, and a track on another layer. So far my rule is this: But it still says a have a collision. These are the pads ...