Questions tagged [digital-filter]

The tag has no usage guidance.

14 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
73 views

Accelerometer to detect when product has been picked up by user

I have a 3-axis accelerometer on my board and i was hoping to use it to detect when a user lifts the device up. I would like to avoid false triggers when the table shakes or when the user nudges the ...
2
votes
0answers
272 views

RC filter - compute output as a function of input for generating waveform

I'm not so deeply into the theory about all this, I may use strange terminology... If I put a square wave through a simple lowpass RC filter, the output will be a sort of "rounded sawtooth", well not ...
1
vote
1answer
48 views

Xilinx FIR filter behavior

We're currently simulating some Xilinx AXI Stream Finite Impulse Response (FIR) IP cores. https://www.xilinx.com/support/documentation/ip_documentation/fir_compiler/v7_2/pg149-fir-compiler.pdf The ...
1
vote
0answers
369 views

FIR filter in dsPIC with DSP Library

I have to make a digital filter with a dsPIC30F, but I don't know much about it. I've read part of the documentation about the dsPIC30F and the DSP Library, and I found a page on Microchip website ...
1
vote
0answers
831 views

Low-pass digital filter for 0-10 V, 4-20 mA input

I'm looking for a little direction or recommendations in how to select and implement a low-pass filter in software as my background in signals and systems is quite weak. In particular, I'm interfacing ...
0
votes
0answers
36 views

Filtering analog audio signal using TLV320AIC3111-EVM

I'm working on a project to filter analog microphone data using the audio codec from TI, the TLV320AIC3111. We are using the EVM However, I'm facing problems with implementing the filters on the ...
0
votes
0answers
91 views

Time delay using IIR filters

I am trying to implement a cardioid pattern with two microphones. I was reading this paper titled "Digital Filter Array Optimization for Directivity Pattern". The link to download the paper is this. ...
0
votes
1answer
468 views

Is this alternator W RPM input circuit ok and how can I improve it?

I need a robust and reliable way of taking a RPM signal from the W terminal of a standard automotive alternator. Most of the time the signal will come from a 12V alternator but there is a requirement ...
0
votes
0answers
68 views

Why do we need an (adaptive) equalizer when we have a matched filter at the receiver?

When both can perform the same task of reducing the effects of ISI, why use both and not just one at the receiver end?
0
votes
3answers
151 views

Predicting decay time of a resonant bandpass filter?

In a typical resonant bandpass filter, resonance is set as none at 0 and full at 1, such that the filter rings infinitely at 1 and not at all at 0. If there is a two-pole resonant bandpass filter, ...
0
votes
1answer
50 views

Filter gyroscope's error from linear acceleration?

I need to use 3-axis angular velocity data for my application, but the gyroscope outputs angular velocity when under linear acceleration (not rotating). Is there a way to filter this error?
0
votes
1answer
105 views

Same z transformed function, but different answers of inverse z transform?

Given z transformed function is E(z)=1/(z+4) I know there are several ways to get the inverse z transform of this function. use partial fraction E(z)=1/(z+4) E(z)/z=1/z(z+4) apply partial fraction ...
0
votes
2answers
166 views

Efficiency of FIR filter in verilog language

Implementing a 4-tap FIR unity coefficients, is this code efficient in power and area ? ...
0
votes
1answer
383 views

Anti-Aliasing Filter example

I need help in solving the below question. Bandwidth of the signal is 1KHz. Use a 12-bit ADC with SNR of 78dB for sampling. the sampling frequency is 12KHz. Choose suitable filter order and cut-off ...