Questions tagged [edge]
The edge tag has no usage guidance.
9 questions
2
votes
1
answer
5k
views
Why does this Edge Trigger Work on input of 555 monostable config?
I recently wired up a 555 timer in a mono stable configuration and found that when the trigger was held low for longer than the configured output pulse width, the output would stay high. After ...
- 169
6
votes
4
answers
26k
views
How to generate edge-triggered pulse
First, a bit of background: I am just a hobbyist with electronics and have very little formal education in the area. I understand most terminology, but generally require a schematic for me to be able ...
- 163
3
votes
2
answers
4k
views
Why is D flip-flop positive edge triggered instead of level triggered?
I'm trying to understand this D type positive edge flip-flop:
simulate this circuit – Schematic created using CircuitLab
I'm having problem understanding why it is positive edge triggered and ...
- 41
2
votes
2
answers
7k
views
Falling and Rasing Edge Detector
I will use a motor adapter in my design.This motor adapter doesn't have a spice model. Therofore I will design inside structure of this adapter. In this motor adapter has a delay and xor gate part.I ...
- 21
1
vote
2
answers
16k
views
How to generate a single pulse using RC circuit from a fixed DC supply without any controller, timer or delay IC?
I have a DC supply (5 V) to turn some circuit on and in that circuit there is a module which uses a specific mechanism (i.e. a 2 seconds width high pulse) to turn on (even if a supply is connected, ...
- 87
9
votes
1
answer
4k
views
Is there an intuitive explanation of the classic edge-triggered flip flop circuit?
I figure there must be a way to understand it in terms of the three underlying latches somehow locking each other out, but I'm not getting it.
Is there a way to understand the edge-triggered flip ...
- 3,105
0
votes
0
answers
270
views
Turn a positive clock edge into a negative pulse to make a 74LS170/670 register file synchronous
This is a follow-up o Why did they make the 74x170 (670) register file asychronous, no CLK input?.
I want to use that "register file" for my project, but I need to make it behave properly as a ...
- 1,669
3
votes
1
answer
3k
views
What is the purpose of the sharp edges (aka mouse bites, aka perforated breakaway tabs) on the PCB?
I have received an NVIDIA Jetson board this week and it has the following edges near the mount holes:
I did a quick search on the internet but was only able to find similar edges on the Raspberry Pi ...
- 133
1
vote
1
answer
4k
views
PWM with programmable Dead Time
I need to make a circuit that generates a PWM signal for a motor. The motor has 2 inputs - P and Q. They are the inverse of each ...
- 169