Questions tagged [execution-time]
The execution-time tag has no usage guidance.
6
questions
7
votes
2answers
448 views
How to set an oscilloscope for measurement of interrupt service routine execution time
I have been developing control software and I need to know how much time it takes to execute an interrupt service routine (ISR).
I have decided to use a dedicated GPIO pin of my microcontroller and an ...
0
votes
2answers
70 views
Is it possible to pre calculate execution speed of micro controller for a given setup theoretically?
I need to work with 5x MPU9250 sensors, i2c 400kHz, Arduino nano 8MHz
also, I have HC-05 Bluetooth device 115200 baud rate serial.
is it possible to pre-calculate loop time to gather data from ...
1
vote
2answers
239 views
Task Execution time measurement on Keil for STM32F103
Is there any builtin feature available in Keil uVision to measure execution time of a function or task for STM32F103?
1
vote
3answers
605 views
Unexpected results when measuring MPU6050 sample rate with RaspberryPi
MPU6050 datasheet says that maximum accelerometer data output is 1Khz, so in theory when measuring time it takes to receive 1000 data samples through I2C, so I should receive all data in no less than ...
0
votes
1answer
55 views
Could memristors be used to improve speculative execution?
I've been reading about different methods of improving processing speed, and speculative processing stands out to me. My question is, could the integration of memristors that are trained by ...
2
votes
2answers
312 views
Length of an interrupt
I know that an interrupt should be as short as possible, however, what is short?
My routine is quite long, but has quite some if-statements, so the execution time is short. But maybe it still is ...