Questions tagged [flex]

The tag has no usage guidance.

6 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
1answer
76 views

How to design FFC's/FPC's Even/Odd pattern in Altium

I want to design the even/odd pattern of FFC (flexible flat cable) in Altium. I don't know the exact term used to describe it, but the recommended drawing of this FFC from its target connector's ...
1
vote
0answers
59 views

Fine-pitch SMD pads on flex PCB using coverlay rather than soldermask

SMD: "Solder-Mask-Defined" NSMD: "Non-Solder-Mask-Defined I am making a thin flex-PCB (0.2-0.3 mm) on which I am going to mount a component which has SMD pads. I would like to also make ...
0
votes
0answers
58 views

Flex PCB USB traces layout

I am designing a FPCB and I'm trying to figure out how to make sure the USB traces impedance is 90 Ohms differential. The USB traces from the USB connector to the MCU are about the same lenght, 27.1mm ...
0
votes
1answer
41 views

Stiffeners needed under DFN parts in flex PCB?

This is the first time I'm designing flex PCB and I wonder do I need to put "stiffeners" under DFN parts which are soldered on flex PCB? Stiffeners would be on opposite side of flex PCB than ...
0
votes
0answers
42 views

How to connect five flex sensors to on esp8266?

I’m using a lolin nodemcu 8266. I was wondering if it is possible to connect 5 flex sensors to one node (to make a glove which detects finger gestures). I’m an experienced programmer but new to ...
0
votes
1answer
163 views

Purpose of solid plane on flex in wireless earbuds

I'm looking at a teardown of Sennheiser Momentum wireless earbuds. It is a rigid-flex design that folds into the casing:  My question is about the flex that sticks out to the right in the picture ...