# Questions tagged [frequency-response]

The tag has no usage guidance.

168 questions
Filter by
Sorted by
Tagged with
107 views

### Can't achieve the goals in designing and simulating Resonator circuit

Goals I need to design resonant parallel circuit and simulate it with LTSpice so that it match with the design requirements correctly. Requirements Source Impedance $R_s = 100\ \Omega$ Load ...
244 views

### Fitting of continuous transfer function

I measure a network's transfer function using a network analyzer and therefore have a set of complex data points, representing the network's gain and phase. I wish to fit a continuous, rational ...
206 views

### How can I estimate TL431 output voltage swings based on datasheet alone?

I am trying to design a series-pass regulator that brings 12V down to 3.3V. If I see a 20 mA step change in current, I would like to stay within a certain output voltage range (±2%). What parameters ...
242 views

### Crossover frequency and resonant frequency

Physically speaking, what is the difference between crossover frequency and resonant frequency? As far as I know, the resonant frequency is the frequency at which the system oscillates. And the ...
98 views

### Frequency Response Function Estimate via FFT Question

I want to estimate the FRF of a dynamic LTI system given experimental input and output data. I know generally the approach is to use a chirp as an input to make sure enough frequency content is ...
162 views

### Is this mosfet stable? Trouble with capacitances

I have the following circuit and I'd like to know about its stability : From what I've learned from basic electronics courses, the first step is to add the parasitic capacitances. I know there is one ...
160 views

### Can I change op-amp supply voltage without affecting circuit behaviour

I am working on an audio project which is based upon various sections of several different schematics from various old musical instruments. I want to make a test board that has multiple different ...
67 views

### Can a system have constant phase response other than +/- 90 deg (and multiples)?

I have seen frequency responses where amplitude response is constant( pure delay) and where phase response is constant(pure integrator). In an integrator the constant phase is -90 deg. In a pure ...
41 views

### LTSpice transient analysis and current amplification problem

Im simulating LC circuit in LTSpice: It's tuned at resonance at 1 MHz in the transient response simulation plotting the source and R1 current. Both of which are equal in amplitude 600mA but with a ...
995 views

### Resistor's behaviour at high frequencies

Looking at the impedance vs. frequency graph 1) At low-frequencies Z=R and hence it would be a straight line. 2) For mid-frequencies, Z decreases possibly due to capacitance, but I'm not sure ...
157 views

### 2-stage BJT CC-EC amplifier [closed]

Using proteus I designed this amplifier: But I got this result: I don't know what is the problem in my design. I've been changing the values of the linking capacitors but didn't get any result.
137 views

### Passive Elements At high Frequency [parasitic effects]

What would the magnitude Response curve for a Resistor, Inductor and Capacitor look like [with parasitic effects not ideal components] ? From what I have gathered they would look something along the ...
732 views

### High frequency response of capacitors

I have studied the fact that the capacitor does not like a varying voltage across its terminals, and it acts as a short circuit initially so that there is no voltage drop across it. If this is true, ...
85 views

### Audio Frequency Response Offset in dB

Say I have some audio device with the following absolute frequency response: I want to shift the curve up, so that the 1kHz point is the 0dB point, and everything else is relative to this point. Am I ...
598 views

### High Pass Filter Design from Transfer Function

I need to design a circuit that implements the following transfer function: $G(s)= G\frac{s+z}{s+p}$ where, G = gain, p = pole and z = zero.
410 views

### Relation between bandwidth, response time and disturbance rejection for a control system

I read the following line in a control system book: Higher bandwidth corresponds to better command following, disturbance rejection and sensitivity to parametric variations. On the other hand, ...
61 views

### How is the sweep type affecting the Bode plots for the same AC analysis in LTspice?

When I do an AC analysis for the following circuit between 0.1Hz upto 20MHz, and by selecting "decade" in sweep types I obtain the following plots: But if I do exactly the same thing only this time I ...
692 views

### Frequency response of MCU decoupling capacitor

I'm designing a board that contains an MCU and an 8 MHz crystal. I was planning on keeping the MCU power/ground localized and isolated from the main power supply power/ground except at a single point. ...
100 views

### VFA vs. CFA Compensation Capacitor Comparation

Here, I am referring to voltage-feedback amplifier (VFA) and current-feedback amplifier (CFA). A basic schematic is given below for each. I.) VFA II.) CFA I am curious about the position of ...
1k views

113 views

### frequency response multistage

hello every one i need ask about frequency response i have an old question of our professor exam in few year, and i try to solve this question many time but i can't so please if any one have idea ...
3k views

### OrCAD PSPice less than 2 connections error while simulating

I just started using PSPice and I don't know much circuits theory but I need to simulate this circuit and find Vout/Vin: I did this using capture but after running simulation I get this error: ...
6k views

### Transfer function gain [closed]

$H(s)$ is the transfer function and we're looking for its magnitude gain. I went from the Laplace domain to the frequency domain by replacing $s$ with $j\omega$. However, the solution didn't ...