Questions tagged [l293d]

The tag has no usage guidance.

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
2k views

L293D 2 Phase Bipolar Stepper Motor

I have an M35SP-11NK stepper motor that I would like to be able to drive with an L293D driver chip. The circuit below is how I've got it wired up so far. I've derived this from numerous sources on the ...
2
votes
0answers
368 views

Can't get L293D to work with raspberry pi zero w

I have the following When i turn GPIO 17: high GPIO 22: high GPIO 27: low or GPIO 17: low GPIO 22: high GPIO 27: high ...
0
votes
0answers
19 views

L293D driver module taking current from USB

I bought an L293D driver shield for Arduino. Upon trying to run my 2 stepper motors I found them struggling to run, voltage drops and all. I replaced my 1.2A 12V adapter with my 7.2V LiPo battery, the ...
0
votes
0answers
85 views

This L293D just blew up. Can someone pease help me figure out why?

I was using a motor driver breakout board with a L293D IC on it, along with a 7805 voltage regulator and a couple of capacitors. I have een using it for 4-5 months and the wire connections stayed the ...
0
votes
2answers
78 views

Can a L293D H-bridge be used for this application?

I'm building a circuit that is needed for a logging device we have. With some of our sensors the current is going in one direction and with others the other way around. That means that we have a ...
0
votes
0answers
248 views

Microcontroller resets with motor driver (L293D)

I am making a simple robot with 2 BO motors driven by L293D on ATmega328P (took out from Arduino Uno). The robot when tested on Uno works fine. But when I put it on the board that I have designed (as ...
0
votes
2answers
667 views

Is it possible to drive a 12V DC motor with XL6009?

I am a beginner in robotics. I am planning to drive a 12V DC motor from Raspberry Pi 2 B. I know Pi does not have that capacity to drive such a device, so I am using L293D motor driver to control the ...
0
votes
2answers
176 views

L293D all inputs high

I want to use the L293D to control 2 motors forward/backward. My question is if I set all inputs (A) high, do I have a short circuit? Because the driver gets really really hot.
-1
votes
1answer
133 views

Connect Multiple L293D Motor Controllers to Arduino

I would like to connect 3 L293D Motor controllers to an Arduino Uno with the hopes of powering 6 different dc motors. I was just wondering how to wire this being that one motor controller (which ...