Questions tagged [lm386]

The LM386 is a "Low Voltage Audio Power Amplifier"

11 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
6
votes
0answers
684 views

LM386 guitar practice amp circuit not working, need help finding mistake

I'm very new to electronics and I built this guitar amp circuit on a breadboard: and it was working really nicely. Now I've decided to put the circuit on a universal PCB which I'll use in the actual ...
1
vote
2answers
44 views

Random Electrical noise LM386

I tried to make a microphone (condenser microphone) amplifier that powers a 0.5W 8 ohm speaker using the LM386, however I have been having random noise issues. Whenever the power is connected, the ...
1
vote
0answers
79 views

Portable Guitar Amp - Distortion, Volume & GND

I have tried following the given schematic There are 3 things I am unsure of (what I tried): The Volume 5k Potentiometer: I have tried adding a volume control to the schematic by placing the ...
1
vote
0answers
82 views

Problem with Simulation Results VS Tested Results for a signal

For the circuit shown i am having some trouble wondering why my tested signal looks like this (i understand that it could be clipping) but when i measure my circuit in the simulation it is correct? ...
1
vote
0answers
2k views

Electret condenser microphone, LM386 amplification… does size matter?

I've built a motorcycle intercom, of which comprises of two amp units, one for the rider, one for the pillion. Both are powered by a 9v battery each, and the option (using a jumper) to enable boost. ...
0
votes
0answers
78 views

Overheating LM386

I am still trying to build a simple audio amplifier using the LM386. I also found some older LM386 in my department, since my previous batch may be corrupted. Using this circuit I rebuilt it using a ...
0
votes
1answer
78 views

Microphone with LM386

I am trying to build an audio amplifier circuit based on this design using an LM386 opamp. On the output side (pin5) an Arduino is connected constantly reading out the pin ...
0
votes
1answer
52 views

555 NOISE BUTTON/ OP AMP

I have this circuit from the image below that I am designing myself. part of this circuit is cut so 2 78xx is present. This circuit is being designed and tested in parts. This part of the circuit has ...
0
votes
0answers
39 views

Analog VU meter with 1 watt lm386 amp

I am building a small cigar box speaker with an lm386 and think it would be cool to have a working analog VU meter on the front. There are obviously a lot of cheap ones from China which I would be ...
0
votes
1answer
92 views

Using an LM386 with input and output transformers for isolation from power supply

The LM386 TI applications notes page 11 show an amplifier. Would like to use this chip with complete isolation of the output speaker and with the addition of an isolated input speaker. Am using ...
0
votes
1answer
1k views

What kind of speaker can be used with an LM386?

I am trying to use an LM386 to drive some speakers. I have both a 4Ω 4W speaker and 8Ω 1.5W speaker. Would I have to build a different circuit for each of these and would the LM386 be able to drive ...