Questions tagged [matching]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
5
votes
3answers
5k views

Custom USB Impedance question

I'm looking at making my own USB cable for a project. The primary issue I'm having is that I'm getting a lot of capacitance in my cable between D+ and D- (400ish pF) which is enough to throw off the ...
1
vote
0answers
700 views

Problem with impedance matching on DIY 4 pole 3.5mm audio splitter

I built an audio 4 connector 3.5mm splitter. The goal is to play a sound clip through a phone's mic input across a call, while recording the same sound clip on the computer. I used the TRRS ...
3
votes
1answer
535 views

Matching mosfets - linear servo amplifier (AB)

I'm replacing a bunch of burnt mosfets in a linear amplifier for a brushless motor. 3 phases Each phase: 3 pairs of totem IRFP240 / IRFP9240 in parallell. (no R in series) My main concern is ...
2
votes
3answers
378 views

Intersection Turning Movement counts

Civil Traffic Engineers have a perpetual data gathering problem. They need intersection turning movement counts to do their studies. This has historically been a manual task. Someone sits by the ...
1
vote
1answer
410 views

Can I plug 4 Ohm speakers to 16 Output directly?

I have Samsung YP-U3 player with Earphone Output 20mW (16Ω) and I want to connect it with speakers taken out from my old laptop that are two 4Ω (1.5W). Can I do it directly or speaker will break down ...
3
votes
2answers
866 views

How do you find matched components?

I am designing a twin-T filter, which has a cut-off around 4.5 MHz. In this filter, both R1 and R2 must be 2 x R3. C1 and C2 must be half of C3. I have selected R1 = 10k and C1 = 3.6pF and that gives ...
8
votes
3answers
2k views

Can I merge two impedance matching circuits?

I've got an RF transceiver (Nordic's nRF24L01+) which shows a typical circuit to match its antenna output to a single ended 50 ohm impedance. I've also got a chip antenna which comes with an example ...

1 2