Podcast #128: We chat with Kent C Dodds about why he loves React and discuss what life was like in the dark days before Git. Listen now.

Questions tagged [module]

The tag has no usage guidance.

6 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
0
votes
2answers
96 views

Should I remove the termination resistor from the CAN Bus transceiver module?

I develop a CAN-BUS receiver (logger) with an ESP32 and CAN-BUS transceiver. The CAN-BUS transceiver modules which I found and bought have both 120 Ohm termination resistors. But the CAN-BUS to which ...
0
votes
0answers
29 views

Connecting BLE module to Lipo battery and recharge it?

I would like to use a BLE module, where I can solder a tactile switch. There should be also the option to charge the module via USB. Earlier I have only worked with breakout boards, where I could ...
0
votes
0answers
56 views

What can i do with a WM8192EU USB module?

I recently came across a wm-8192eu usb module from an old electronic doorbell. It had a socket on the board that it just slid right out of. When i googled the chip it showed a bunch of usb wifi ...
0
votes
0answers
52 views

Verilog code for SET and RESET

I'm trying to write verilog to synthesize a circuit which operates as follows: At the rising edge of SET if RESET is low then OUT is set high and it will be reset when RESET is high (the first cycle ...
0
votes
2answers
50 views

Instantiating modules in SystemVerilog

This is a picture of a system that I am building: (original) I am writing SystemVerilog for the Counter4to3 module, whilst the other modules (Full adder and half adder) have already been provided to ...
0
votes
0answers
33 views

Timing relay for delayed pulse

I'm trying to achieve this Tried many timing relays but couldn't find one with this function. There are ones to delay both rising and falling edges but it doesn't work when delay is longer than ...