Stack Exchange Network

Stack Exchange network consists of 175 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [motion]

Motion may refer to the motion of objects, like rotation, drop or picking up, for which **motion sensors** are used. Or it may refer to the motion of persons, for which typically **PIR motion detectors** are used.

1
vote
1answer
71 views

Compensate centrifugal force in accelerometer measurements

I'm working on a project that includes counting the revolutions of a cylinder connected to an engine. This engine runs at a minimum of 5 revolution per second and a maximum of 9 revolution per second. ...
0
votes
1answer
186 views

Connect 240v PIR motion detector to Raspberry Pi

I want to connect a 240V PIR motion detector directly to my Raspberry Pi 3. Inside its plastic case I found 2 PCBs. One is the power supply board which has a 24VDC relay, a S9013 NPN transistor, ...
0
votes
1answer
607 views

how to program BMI160 inertial measuremen unit to latch detection flags

How should BMI160 registers be set to enable detection flags to be set in INT_STATUS? For example, how to get TAP_STATUS byte-0 bit-5 s_tap_int to set if XDK110 is tapped? I don't need actual ...
1
vote
0answers
218 views

Accelerometer - Offset correction

I'm using the MMA8453Q for motion detection. The accelerometer is mounted such a way that when it is stationary, X & Y axes are at 0g & Z-axis is at 1g. My usecase is: A tilt across any axes ...
1
vote
0answers
194 views

Is “transient detection” exclusive to Freescale?

I'd like to detect the dynamic component of acceleration, i.e. the change in acceleration, and generate an interrupt when such change is detected. I see that MMA8451/2/3 calls this "Transient ...
0
votes
0answers
21 views

RCWL-0516 Microwave Radar Sensor

I have recently been interacting with these cheap radar modules from China and works fine specifically the RCWL-0516 Microwave Radar Sensor. Now I wanted to integrate the entire circuit into a custom ...
0
votes
0answers
31 views

Simple Animatronic - slow repeating/reciprocal motion for a window display

I am trying to rig a contraption to pull a model hot air balloon back and forth along a curved horizontal track. Its motion is both horizontal (6’) and vertical. I have built the track and rigged the ...
0
votes
0answers
21 views

How does “Tilt on Wrist Interrupt is detected with one accelerometer axis” work?

bma456 has a tilt-on-wrist detection interrupt. When ever the device is rotated more than a minimum of 12 degrees to gravity, an interrupt interrupt is generated. In the data sheet, it says "The Tilt ...
0
votes
0answers
183 views

Long Range Motion Detection solutions

I'm trying to find solutions for the security of an outdoor area (2km long and 1km wide). We want to detect any breach through the borders of the area, if someone sneaks in and/or someone goes out. ...
0
votes
0answers
349 views

Relate Pyroelectric Passive Infrared Sensor analog output to the digital “motion detected” signal

I'm using a digital PIR sensors from the picture below. it outputs a high (3.3V) on motion detection, low (0V) when no motion was detected. The analog sensor component of this motion sensor is the <...