Questions tagged [offset]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
0
votes
3answers
3k views

Can someone explain this gain & offset op-amp circuit?

I'm having trouble understanding the circuit in the photo below. I know that it's a gain and offset amp designed to convert 0-2.5 V range to +/-10 V range (hence it has a gain of 8 and an offset of -...
1
vote
2answers
1k views

Piezo into 0-5V ADC, with offset center voltage?

I want my piezos to have a center voltage at 2.5V for a 0-5V ADC input on Atmega328, so it can sense force in both ways - one way would be >2.5V and the other will be <2.5V. Will this circuit work?...
2
votes
2answers
1k views

Adding offset voltage to sensor signal

I have a pressure transducer outputting 0-5V which is sampled by an ADC with a 0.5V minimum input voltage. I need to offset the sensor output voltage by a fixed voltage of 0.5V. I've looked at an op ...
2
votes
2answers
5k views

Operational amplifier parameters: Input bias current, Input offset current, input offset voltage

I've been reading about input offset voltage, bias current, and current offset for a few days now and still can't get some things straight. I'll summarize what I understand and then pose the ...
1
vote
1answer
8k views

Offset an input voltage of -2.5V - 2.5V to 0V - 5V? [duplicate]

I have a circuit input which provides a voltage range of negative 2.5 volts to positive 2.5 volts. How do I change this so the output voltage is 0 - 5 volts? simulate this circuit – Schematic ...
1
vote
1answer
68 views

A question on factors affecting the offset removal of an opamp circuit

I will use a function generator module which outputs 0-1V sine-wave for frequencies of interest from 0.5Hz to 30kHz importance. So my input will be 0-1V sine wave but I want to obtain an AC sine wave ...
1
vote
1answer
303 views

How to compute DC offset of analog circuit?

I have an analog circuit which has an input voltage range Vin of 5V - 10V and output voltage Vout. One can assume that the circuit has been simulated and a DC sweep of Vin with a range from -10V to +...
0
votes
4answers
552 views

Offset when trying to convert square to triangular wave

Hi I constructed a circuit to create a 1Hz square wave with LM741 Opamp. The first part makes that and it makes it perfectly. But I need to convert it to a 8Vpp triangular wave. Without any offset, I ...
0
votes
1answer
698 views

What is meant by “adjustment of the output gain and offset” of a Force Sensitive Resistor interface circuitry?

A FSR (Force Sensitive Resistor) is a sensor which lowers its resistance when there is force upon it. At idle state (no push force) it has a high resistance (~ MOhms) Interlink Electronics has ...