Questions tagged [offset]

The tag has no usage guidance.

12 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
374 views

High voltage DC offset servo

I'm working on a project and I need some assistance. I have an audio tube amplifier output stage that I need to have adjustable operating points while maintaining a DC null at the output. [![enter ...
1
vote
0answers
46 views

Rressure sensor offset removal

I have a pressure sensor that has 200 mV offset. I wanted to remove this offset and double the result (to remove any present noise) so that be able to calibrate the sensor easier. So far I have used a ...
1
vote
2answers
55 views

Help selecting feedback and ground resistors for a gain and offset circuit

I have an input signal from -3.3V to 3.3V and the ADC I would like to use can only read from 0 to 3.3V. I also have access to a stable source of power at 3.3V. From previous visits, I have tried to ...
1
vote
0answers
92 views

PIC ADC Protection

I am working on a project that samples a 1 kHz signal @ 20 kHz, the signal is 5Vpp biased on +2.5V that way everything is fine. I want to make a protection schematics to work along my offset. I am ...
1
vote
0answers
233 views

Accelerometer - Offset correction

I'm using the MMA8453Q for motion detection. The accelerometer is mounted such a way that when it is stationary, X & Y axes are at 0g & Z-axis is at 1g. My usecase is: A tilt across any axes ...
1
vote
1answer
224 views

ACPL-C79B problem

This is my first post on this forum. I have a problem with an isolation amplifier and i hope there's someone here who can help me out. Let me explain my situation. I use an ACPL-C79B from Avago to ...
0
votes
0answers
28 views

C code to MIPS (offset)

Suppose $t0 stores the base address of word array, $s0 is associated with position, and $s1 is associated with offset.I have to convert the following program segment into Assembly and write down the ...
0
votes
1answer
43 views

How calculate the error offset or the noise threshold for MyoWare and FSR sensors?

I am working on EMG and FMG signals to extract time domine features and i need a threshold value for some features. I must calculate it from the characteristics of MyoWare and FSR sensors.For the ...
0
votes
1answer
38 views

Need help calculating current and understanding Vos in an op amp

I'm trying to solve a circuit that uses an op amp with a +-4mV offset but I've run into two problems trying to find output offset voltage. When looking at the solution to the problem, I noticed that ...
0
votes
0answers
162 views

Negatively offset signal on op-amp

I am simulating the use of a tl074 quad op-amp and i have configured one of the op-amps as a non-inverting op-amp, where R1=1 Meg and R2=4 Meg and the supply voltage is 9V. Every time i put a signal ...
0
votes
1answer
127 views

Remove bridge offset before ICF amplifier or at FB pin?

I'm making project where I would like to read from stain gauge sensor. It will use only one 1k ohm (or 350 ohm) strain gauge and 3 dummy resistors to complete bridge (1k or 348 ohm). I'd lik to feed ...
0
votes
2answers
877 views

Adjusting the offset of the output of a UA741CN opamp

I've the following schematic for a UA741CN when there is NO offset: simulate this circuit – Schematic created using CircuitLab Question: Why do we need the diode and the two resistors to ...