Questions tagged [panel-mounting]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
1
vote
2answers
51 views

Best way to interface panel mount buttons as this one

I need to work on a panel for an industrial product. The idea is that the signals from these buttons go to a PCB with an MCU which then communicates with a central MCU about the state of these buttons....
0
votes
0answers
9 views

Installing 4 ploe Rccb

Could I install 4 pole RCCB for unbalance 3phase load (like residential building) ? How does 4 pole RCCB work? Thank you.
0
votes
0answers
98 views

Panel mount micro USB extension cables: how do they work?

I need to expose the usb port on an arduino pro micro to the outside of a project box. I've been looking for some sort of panel mount extension cable, and all I've been able to find are ones that look ...
0
votes
1answer
38 views

What does the term 10GA CT-PT means for a CT-PT wiring?

We have a MCC in our garage of commercial outlet facility. The bucket with the metering unit needs to be configured with the GE-PQM 2 (Power Quality Meter),and CTs and PTs are required to provide the ...
0
votes
1answer
80 views

Can a normal USB C panel mount socket be used to receive USB PD?

I'm building a lamp that has (up to) three wall-mounted units connected to a central control box. Each one gets three low-voltage control signal wires and 12V 3A DC power. I'm figuring that a USB PD ...
3
votes
1answer
481 views

Is it necessary to provide surge suppressor to every control relay?

We have a motor control centre installed in garage for a commercial outlet. The MCC has a SMC-Flex ( Low voltage soft starter). The control relays (700 HA33) are connected to the SMC control ...
2
votes
2answers
1k views

Best practice for adding Resistor to PLC cabinet

My Micro-step drive and PLC need a simple resistor network between their i/o ports.The optocouplers in the stepper drive have a max input current of 15mA, while the controller needs to output at least ...
0
votes
3answers
41 views

Looking for a dc 2pin connector with latch [closed]

I'm looking for a pair of connectors with following features. about 10V rating (no high voltage) 5A 2 pins latch which will prevent from accidential unplug panel mount I want to mount the socket on ...
0
votes
2answers
401 views

How do I attach an IC chip to a DIN rail? [closed]

I am using a 74AHCT125N to shift up voltage of pwm signal. The problem we are having is how to attach this chip to DIN rail. We were thinking of using a DIN rail mounted PCB. I am looking for ...
1
vote
1answer
68 views

Connector Identification; How to Case Mount

I have these connectors and need to case-mount the female part of the pair. I've been trying to find out their mfg/part no so that I can look at the spec to figure out how to mount it. No luck. The ...