Questions tagged [pcb-simulation]
The pcb-simulation tag has no usage guidance.
9 questions
1
vote
2
answers
59
views
Help with format of Altium Spice model
I am attempting to create a model of a load for use in an Altium Spice model. But I am unable to get it to work. What I have done is accurately measure current consumption of my device. My concept was ...
- 139
0
votes
0
answers
31
views
Is this LTSpice simulation of arduino's command for relay corrrect?
Here is a LTspice simulation for based on the video Design Relay module PCB using Altium designer
To me, it seems ok, but i am lacking of experiences.
What is your opinion on this LTSpice simulation ...
- 129
1
vote
0
answers
179
views
Searching the Spice model of the Liteon optocoupler LTV-817-A
I start learning simulation with "Altium Designer". Unfortunately, i did not find the spice model for the Liteon optocoupler "LTV-817-A".
Do you know where i can find it or a very ...
- 129
0
votes
0
answers
47
views
EMI performances observed better for stripline routing with pth rather than stripline with blind via
The circuit is: A fast switching driver (Lvth buffer) is transmitting a signal to Leon processor receiver and it also has a series termination.
Stackup: top(L1), gnd, sig1(inner lyr3), 2.5V plane, ...
8
votes
3
answers
2k
views
How are RF filters constructed?
I want to know what filter circuits look like in the RF (MHz-GHz) frequency range. Are they just like low frequency LC filters, but with appropriately adjusted component values?
For example the VLF-80+...
- 161
1
vote
0
answers
41
views
Near-end scan different frequency magnetic field propagations in ideal DC source
I installed a simple PCB on Ansys siwave. I defined the power lines. And I defined an ideal voltage source that gives only 18 V on the pins. I set the near fields analysis as you can see.
...
- 772
0
votes
1
answer
56
views
Some of my LEDs managed to light up but the others just won't work no matter what I do, what could be the reason for this?
This is a picture of my schematic and I want to ask what could be the reason why the ones below won't light up
1: https://i.sstatic.net/REuys.png
- 1
1
vote
0
answers
60
views
How to properly handle mixed RF/digital design in HFSS 3Dlayout
I have a big design imported from Altium into HFSS 3DLayout with several RFIC that I want to simulate. RF and Digital (SPI) nets are included in this design.
I'm interested mainly in the RF side of ...
- 121
0
votes
2
answers
66
views
Simulation tools for FCC SDoC testing
For as expensive as FCC-conformity lab testing costs, I am curious if there are any simulation tools that could help in producing an approximation of what a lab test would find, given a PCB design. ...
- 735