Questions tagged [production-testing]

Production Testing is sometimes called in-line testing. That is the PCB or assembly is completed but is only a sub-assembly. There can be many sub-assemblies to get to the final product. In-line testing is used to make sure sub-assemblies are fully functional per engineering standards, then sent to the stock room to be issued for the next assembly level. This procedure assures but does NOT guarantee that the final product will pass final testing.

3 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
4
votes
2answers
187 views

How to write or generate test cases(or vectors) for automated production testing of embedded electronics?

My question is following: Assuming I have developed some embedded controller(board) which has some tens of digital inputs and outputs. It has embedded firmware, which performs some logical functions. ...
1
vote
0answers
64 views

Circuit testbench nailbed: how to test the pots?

Imagine I make an analog circuit, lets say a guitar pedal circuit (in a PCB of course). How can I test (automatically if possible) the potentiometers functionality, when testing in a nailbed ...
0
votes
1answer
33 views

Fault modelling stuck at fault for combinational circuit

A circuit has n inputs and n outputs. It is implemented only using AND, OR and NOT gates. Further, there are no fan-out branches. What is the number of s-a faults that remain after fault collapsing? ...