Questions tagged [qtouch]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
0
votes
1answer
57 views

Qtouch with non-Atmel microcontrollers

Simple question really. Can I use Atmels Qtouch library with non-Atmel MCUs (such as an STM32)? It seems like Atmel has a solid line of capacitive touch ICs, ...
0
votes
0answers
151 views

Why does my IR receiver PCB only work when I touch the sensor pins?

I have designed a PCB based on a schematic which I am pretty sure that is correct and I have tested the schematic several times on the breadboards and all of them worked properly. But, after I ...
0
votes
1answer
99 views

QT1070 inconsistent readings on touch pins

I recently transitioned my projects capacitive touch IC from using the MPR121 to the QT1070. I am getting irregular/inconsistent readings on one of the touch pins. In this particular situation, it ...
2
votes
1answer
105 views

AT42QT2160 capacitive touch controller inverted Cs voltage - no touch detected

I'm trying to make my own development board for the AT42QT2160 Touch controller, since the original one was discontinued. I've designed the PCB with 8 buttons and a slider consisting of 8 sections. It'...
0
votes
0answers
67 views

QT600 Under Atmel Studio 7

Using the QT600 development kit under Studio 7 in order to develop a touch interface, I can not get the kit to show up when not in programmer mode. I've managed to write the example HEX onto the ...
1
vote
1answer
747 views

Which MCU (Atmel) I can use with QTouch library?

Some MCU have QTouch support - # touch channels implemented as a hardware. Is it true that QTouch library was designed only to work with such MCUs? Can I use it with, for example, 'old' ATmega48? Is ...
1
vote
1answer
857 views

ATTiny45, LED strip, MOSFET, touch interface, but Vcc drops and tiny resets

I've developed a very little board with the ATTiny45 and mosfet (STD35NF06LT4 - http://www.farnell.com/datasheets/1689946.pdf ) to drive a high power LED strip at 24V. I have a 5V dc/dc converter (...