Questions tagged [sample-and-hold]

Anything related to sample and hold (S/H) circuits. S/H circuits are analog circuits whose purpose is that of sampling the instantaneous value of an analog signal and store that value for a predefined period of time. They are sort of analog memory circuits, and they are often employed as the first stage of analog to digital converter systems.

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
0answers
25 views

Data path in logic circuit

In the fig below is the path from CLK of 1st FF to Output(DataOut1) a valid data path. If so why is it not shown? Is it because its just the combination of PATH2 and PATH3? Thanks.
1
vote
0answers
358 views

Sampling analog signal at 100khz with raspberry pi

I want to sample a ultrasonic wave at 100 Ksps. Currently i am using Raspberry pi and an external adc communicating with each other vis I2S at 96Khz. Since raspberry pi cannot support higher speed ...
0
votes
0answers
40 views

Conditional analog sample and hold (analog override?) - circuit suggestion request

Preamble: I have a LED driven by an opamp-based constant current source (CCS). It works fine, I can set up current required and it is reasonably stable. The problem is, that LED forward voltage drops ...
0
votes
0answers
33 views

Replacement of BSV81 transistor

A 40 year old cruise control unit (sample and hold circuitry) has failed on me and I'm looking to replace a BSV81 transistor to see if it fixes my problem. This is an old n-channel depletion mosfet. A ...
0
votes
0answers
85 views

Buffer requirements for S/H circuits

I am trying to solve question 11.10 which is taken from 2001 GATE IN paper. So I think the answer is (a) because the input buffer which faces the analog input needs a higher slew rate in order to ...
0
votes
1answer
127 views

Bypass Gate-to-trigger-converter via switching jack

Goal I like to trigger a LF398 Sample-and-Hold IC via a 3.5mm Jack (modular synthesizer). The desired behaviour would be: if a cable is plugged in, incoming signals will be converted to short ...
0
votes
1answer
42 views

What kind of wave should i feed the input of sample and hold,which is in the sar adc

There is sample and hold in the sar adc,but i am not sure that i should feed a ramp wave or sine wave to the sample and hold? Are there any relations to sar adc output and sample and hold input wave?
0
votes
1answer
63 views

Analog to digital controller-Sampling rate

One method to design a controller for a digital control system is to first design it in the s domain and then convert it. However, choosing a suitable sampling period is important. In most problems ...
0
votes
1answer
72 views

PSRR - Testing Fixture

I have to design a PSRR test fixture with a 2.4KHz signal imposed on a dc power supply. I can do it using a bias tee at rf but the size of the components at audio confound me. The application is a ...