Stack Exchange Network

Stack Exchange network consists of 174 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [soic]

The tag has no usage guidance.

9
votes
1answer
6k views

Is there a difference between SOIC and SOP?

I'm looking at two integrated circuit packages: SOIC and SOP. They seem (almost) identical (pitch, overall size, etc...) SOP SOIC Is there any important differences between these two packages that ...
4
votes
4answers
1k views

SOIC -16 IC Orientation

I've just soldered a SOIC-16 am26c32 on to a breakout board. The datasheet shows the orientation of the chip by means of a semi circle at one end (http://www.ti.com/lit/ds/symlink/am26c32.pdf). ...
3
votes
1answer
625 views

Do SOIC op-amps packages behave differently from DIP?

I have acquired some mcp-6002 op-amps in a SOIC package instead of the DIP I normally use. I have solder these to a SOIC to DIP "converter" so to fit on the breadboard. If I connect them as I do with ...
1
vote
2answers
45 views

What would an acceptable replacement be for a discontinued Motorola HCT174A?

I am trying to replace a Hex D Flip-Flop on an Amiga A4000 motherboard. The original chip has the label HCT174A XAA346 I believe the datasheet describing this ...
1
vote
1answer
53 views

WIll the multimeter continuity test on the SOIC - DIP adapter spoil my IC?

IC : L9637D for ISO 9141 bi directional serial comm. Multimeter: Mastech I am mounting an SOIC 8 IC on an adapter(regular Soic to dip adapter), so I can mount the adapter on a bread board for use. ...
0
votes
1answer
51 views

tmp36 soic, doesn't work, but the to92 version does, am I missing something obvious?

I am using a tmp36 temperature sensor to measure temperature (with an attiny 85), when I put 5V across the GND and Vs pins of the to92 model the Vout is not 0 (I can't remember the exact value now but ...
0
votes
1answer
64 views

How to prevent SOIC8 clip from backfeeding

I'm trying to read the flash ROM using a SOIC8 clip, on board. I am horrible at surface mount soldering. Is there a way to use the clip on the board, without removing the chip, and not have the SOIC8 &...
0
votes
1answer
230 views

Clip type for in-system programming (SOIC8 vs DIP8)

Updated: What clip can I use to connect to this [specsheet] SPI flash chip in a DIP8 package? note: this picture is of a motherboard that belongs to someone else, but mine has the same manufacturer,...