Skip to main content

All Questions

Tagged with
Filter by
Sorted by
Tagged with
1 vote
2 answers
209 views

STM32F417 DFU bootloader fails to start HSE crystal

I have a problem with a custom STM32F417 board. On some boards the DFU bootloader works fine, while on other ones it fails to connect by USB. In my custom firmware all boards connect fine by USB. ...
jpa's user avatar
  • 9,656
0 votes
0 answers
178 views

Role of RTS and DTR With CH340X, STM32WLE5, STM32CubeProgrammer

I am trying to (design a PCB where I will) program a STM32WLE5C8U6 via UART from my laptop using a CH340X in between. The CH340X shows this application circuit in the datasheet: I understand what the ...
nothing's user avatar
0 votes
1 answer
63 views

Connecting TTL-232R-5V-PCB to STM32F103C8T6A bluepill via OTG and installing boot to this STM32 microcontroller

I have TTL-232R-5V-PCB and STM32F103C8T6A bluepill board. I am working on installing bootloader to this bluepill board on that way, I have searched on the web about it but all people connected them ...
serkanhelvacioglu's user avatar
0 votes
1 answer
837 views

STM32F103 programming using a USB port and CubeProgrammer

I created a custom board with an STM32F103C8T6 microprocessor and Iwant to use the USB to program the board using the STM32CubeProgrammer. I found out thanks to a user on Stack Exchange that it is not ...
Y-E-Quit's user avatar
  • 121
2 votes
2 answers
334 views

Programming STM32F103C using USB

What's the Problem? I created a Custom 'Development/Discovery'-Board and want to program it using USB. I saw in the Datasheet AN2606 that it is not possible to flash the program via USB. What I tried ...
Y-E-Quit's user avatar
  • 121
3 votes
1 answer
4k views

STM32: Minimal USB bootloader circuit

I would like to use the builtin USB DFU bootloader of STM32F107 chip. My MCU is powered by the device, I don't need to use 5V from the USB. So far I have connected pins PA11, PA12 and GND directly to ...
Honza Vojtěch's user avatar