All Questions
Tagged with transducer pressure
7 questions
0
votes
1
answer
79
views
Help testing Pressure Sensors
I have a few ME600 Metallux sensors that I harvested from some discarded products. I want to build a project with these but would like to verify they work before getting too far. From the datasheet ...
- 1
0
votes
0
answers
401
views
Pressure to current conversion
I was trying to convert the pressure values (in psi) into 4-20mA current. The range of pressure values I have chosen is between 0-10Psi. But according to the link given below the pressure from 3-15Psi ...
- 11
1
vote
1
answer
935
views
How to read the following datasheet of a sensor?
I wanted to write about static and dynamic characteristics of the Honeywell pressure 19mm transducer. I found my sensors datasheet but could not find the following characteristics mentioned in the ...
- 41
1
vote
0
answers
280
views
What type of sensor connection would be the most suitable?
I have a pressure transducer with a 6 pin bayonet MIL-C-26482 male connector. I need to wire this connector with a 9 pin female D sub analog input connector and I am not sure how to do so.
Schematic ...
- 65
0
votes
1
answer
686
views
Pressure transducer being read using LabVIEW
I understand this is not a typical question for this forum, and that the NI LabVIEW forum would be better (I posted there too), but I am hoping that someone who is proficient in LabVIEW will see this. ...
- 11
0
votes
0
answers
195
views
Pressure Transducer to complete circuit
I'm using the Adafruit Feather nRF52 to build the HIDScan sketch which essentially allows completed circuits to transmit keys over bluetooth. I have a switch that connects from pin A0 to GND, and ...
- 95
0
votes
1
answer
157
views
What are the range of pressure values we receive from an ultrasonic sensor?
While trying to receive ultrasonic waves from a Sonar using a pressure transducer what are the range of values of pressure I can get.
I need these values to buy necessary equipment for doing the ...
- 783