A message from our CEO about the future of Stack Overflow and Stack Exchange. Read now.

Questions tagged [video-transmitter]

Questions related to transmitting image frames, primarily wirelessly

Filter by
Sorted by
Tagged with
0
votes
0answers
37 views

help identify the SMD AK1629

Failed DVR Suspect that burned down this detail:prozvanivatsya short circuit in both sides can't understand which part to replace?
0
votes
1answer
114 views

Led panel sending and receiving card working

I understand how a RGB LED panel is driven from sparkfun's explanation (here). From manufacturers like Huidu and Novastar I get that in a setup you often need a sending and receiving card. Like you ...
0
votes
1answer
110 views

4 pin connector is melting even with 5 volt and 0.1 amp power supply, Why?

I am using a connector as shown: . I am using this to connect to my camera, which works at 5 volts and 0.1 Amp. But this connector works only for few days and then the plastic portion of the ...
0
votes
1answer
104 views

Transistor Video Amp Circuit Help

I built the below video amp & it worked nicely.But it is One in One out video amp. http://www.learningelectronics.net/circuits/video-amplifier.html Now I want One in TWO out Video distributor.I ...
0
votes
1answer
347 views

Can we use ethernet cable instead of coaxial cable without adaptors.?

I am a mechanical engineer. Trying to build a computer vision system using endoscopic camera. I have a camera with 4 pin input, 2 input pins for power supply of 5 volt and 2 input pins for video ...
0
votes
1answer
359 views

What does a TV receiver circuit look like? [closed]

I found a few circuits for TV transmitters, but no receivers. I've looked at other simpler RF transmitters and receiver, but it's not obvious to me how to reverse the circuit that I have. I want ...
0
votes
2answers
151 views

How sensitive are the DVI sync signals?

We're trying to output a full mono-colored screen signal in 640x480 resolution over DVI to a Samsung monitor from an FPGA board. The problem we have is that we don't get any picture showing, instead ...
0
votes
1answer
58 views

UHF TV transmitting circuitry [closed]

I would like to know your opinion what are existing solutions for building a small (<5W) UHF TV transmitter. The problem is every circuit or schematics I find already uses separate audio/video ...
3
votes
1answer
610 views

Displayport clock recovery

The displayport protocol runs at a fixed frequency of either 1.62GHz, 2.7GHz, or 5.4GHz. The pixel stream (strm_clk) it carries runs at an arbitrary frequency and is likely to be asynchronous to the ...
-2
votes
1answer
68 views

USB RF Videotransmission, is it possible? [closed]

I am thinking about building my next rc plane complete from scratch. I wanted to do the programming by myself, so I have the problem, that I can't use any 5.8Ghz video transmitter because I can't ...
0
votes
3answers
126 views

What considerations should I have when selecting a microcontroller for fast read and throughput?

For a project at work I am tasked with selecting a microcontroller to facilitate video transmission. The microcontroller will read H.264 encoded 1080p30, 30 to 40-second, video files (~500 MB) from ...
0
votes
1answer
128 views

How is this small drone able to transmit video to such long distances? And that too an HD video? [closed]

I am an amateur enthusiast and a novice, thus please bear with me. I was having the look at the http://www.proxdynamics.com/products/pd-100-black-hornet-prs drone. It weighs 18 grams and is able to ...
0
votes
1answer
527 views

What happens to 5.8 GHz signals when too many transmitters are in a confined space? [duplicate]

I'm helping set up an Airsoft arena in the UK and I plan to have RC-FPV cameras mounted on the weaponry and masks which the players use/wear (similar to wireless drone cameras). As it's an open space ...
0
votes
2answers
3k views

Do i really need two grounds

I'm a quadcopter FPV addict, and I'm building a new one. As pointed out i will first explain some acronyms of the rc world PDB (Power distribution board) CCD (Type of camera sensor, cmos ccd... not ...
0
votes
2answers
351 views

How to tap out video signal from a computer or a TV [closed]

I am designing a TV transmitter as given in the link below: http://www.electronicshub.org/tv-transmitter-circuit/ My question is, where from do I give the video input? For the audio input, I can ...
-3
votes
1answer
138 views

receive a video file with a microcontroller [closed]

I want to send a video stream to a microcontroller via wifi. what microcontroller choose for this task? -Must take into account that the video will be transmitted through a phone -The video will be in ...
3
votes
1answer
483 views

Low-Power Video Transmission for IoT

I am currently developing an apparatus for feeding and monitoring my dog remotely. The basic idea is to make this using 2 main components: The first component will be composed of a camera pointing to ...
-1
votes
2answers
732 views

How do I do real-time streaming of video from a PIC32 with camera/Wifi module onto Amazon S3?

I'm looking at RTP/SIP stacks but don't know where to start. What are Live555, MPEG DASH, oRTP, and ffmpeg? Can they run on a PIC? I'm thinking 720p at 15 or 30 ips. I have code working to upload ...
3
votes
3answers
853 views

Separating the AM and QAM components in PAL signal demodulation

I'm attempting to emulate the modulation and demodulation of a PAL video frame in software, but I'm having trouble understanding how the AM (luma) and QAM (UV) components of the signal are separated ...
-2
votes
1answer
1k views

Long-range RF comm with decent data rate [closed]

I'm building a quadcopter powered with Arduino. For testing purposes, I'm currently using bluetooth. In the future, however, I would like to have some form of fairly long range communication that also ...
0
votes
1answer
100 views

Transmitting AV signals one way

I have a video feed that's two AV cables (one sound, one video) and I'm looking to transmit them from the source to about 100-200 meters away. Specifically, I need some sort of transmitter/receiver ...
0
votes
3answers
11k views

Video stream over RF

I want to stream video from a camera 640x480 frame of 8-bit approximately. I don't want to use wi-fi. I capture the data, encode it, transmit the signal over RF and receive it. Decode the signal. My ...
1
vote
1answer
3k views

Video wireless streaming efficiency (analog vs digital)

I was wondering about the best way to transmit a real-time video (wireless).I do not need to be high quality video, so I've bought this camera module: Camera module Camera datasheet Now I need to ...
1
vote
2answers
2k views

How do coaxial cables carry information that a TV can intercept and display?

Is there a specification for this? Like, say, at the backside of a cable box there exists a singular coaxial cable that is meant to be plugged directly in the back of the TV. The TV must be set to a ...
0
votes
1answer
3k views

What will I need to send Video over bluetooth or WiFi to Android phone [closed]

I don't know much about electorics I'm programmer and know some stuff about digital electronics that I learn at school, but I have this idea to send video data from a camera (I found on Alibaba CCD ...
1
vote
1answer
437 views

How to transmit HDMI data over fiber

I need to send video data over a fiber optic cable. The video input is coming via an HDMI link. The fiber optic link is already carrying some other data (an FPGA is controlling the link), so the video ...
2
votes
2answers
2k views

Microcontroller used to transmit video?

I need help choosing a microcontroller for a project I'm doing. This microcontroller needs to do the following: 1) Interface with a low resolution camera, obtain video feed from it, compress it and ...
3
votes
1answer
848 views

Cloverleaf possibly blew out transmitter?

I went ahead and built a Cloverleaf antenna, right-hand polarized, for a video transmitter, transmitting @ 1280MHz and 800mW. After about a week, however, the transmitter stopped transmitting. I'm ...
2
votes
2answers
46k views

Transmitting a video stream through a microcontroller

I'm working a a project that currently works well but this year we want to expand it by collecting data from it, independent of its current functions. We have set up an iPad App to control an Arduino ...
3
votes
3answers
5k views

Transmit video wirelessly from on board camera over short distance [duplicate]

Possible Duplicate: Cheapest way to wirelessly transmit video I asked a similar question a few days ago, but I think I was unclear about my requirements, and they have changed a little since then ...
4
votes
1answer
732 views

Cheapest way to wirelessly transmit video

I'm really big on building RC vehicles. I want to hook up a video camera which can transmit video signals, but don't know what options I have available. My only requirement is that it has to be as ...
2
votes
1answer
2k views

Using Bluetooth to Send Video

I am a second year Electrical Engineering major. I have done a little with the Arduino, but it is not powerful enough to handle video (from what I understand). I would like to capture video from ...
0
votes
1answer
486 views

Can anyone identify this type of connector

I have a Lawmate 2.4 Ghz Video transmitter which has a small 4 pin input plug. I want to find out what the proper name for this type of connector so I can buy spares for it - maybe someone here can ...
2
votes
3answers
553 views

Want to make a UAV

I've been inspired by the guys at DIY Drones and I'm toying with the idea of making a UAV. To transmit the sensor data, I was thinking I'd go with a 60mW XBee, but I also would like to transmit live ...
3
votes
1answer
387 views

Airwave TX “BYPASS” capacitor

I'm using an Airwave 663 module. It's a 5.8GHz FM video + stereo audio transmitter module. Here is the datasheet: http://www.airwave.com.tw/specification/RF%20modules/AWM663TX.pdf It is apparent that ...