Skip to main content

All Questions

Tagged with
Filter by
Sorted by
Tagged with
2 votes
2 answers
241 views

Modelling I2C capacitance for cables under water

My setup works fine with following combination of hardware: Raspberry Pi4 connected to a TCA9548A I2C Multiplexer from Texas Instruments, whereas each channel is connected over 4wires (GND, VCC, SDA, ...
Marco Bobinger's user avatar
0 votes
2 answers
151 views

Turn off LED when submerged in water

I want to do a simple project where an LED turns off when it is submerged in water. I thought this would be simple because when you short the two leads of an LED with wire, it just shorts the power ...
DragonflyRobotics's user avatar
0 votes
1 answer
121 views

PCB surface finishing for underwater use

I need to find a very cheap way to detect water ad specific levels. No needs to have a linear measurement of its height. I'm thinking about a simple FR4 PCB, with several couples of tracks. Each ...
Mark's user avatar
  • 1,450
3 votes
1 answer
416 views

Dipole Sleeve Antenna design in fresh water - Transmission frequency and emitted power?

Hello dear antenna enthusiast, I would like to receive and emit EM signals with a dipole antenna in the range of **433.9 to 434.5 MHz in fresh water. So I chose a half-wavelength dipole sleeve-...
AndRe's user avatar
  • 55
0 votes
2 answers
132 views

Is it safe to build a floatable speaker?

I'm thinking of building a floatable speaker to float along beside me in a lake or a small river while tubing. I've got some speakers and the following 12V amp: DROK Amplify Module Audio Component ...
tbraun's user avatar
  • 1
1 vote
0 answers
122 views

Quadcopter plummeted into the ocean

We have a quad copter which had an arm partially detach mid-flight, which in turn destabilized the vehicle, plummeting it into the ocean. After two hours of searching we were finally able to recover ...
Joshua Burns's user avatar