I agree with all the answers so far but would like to add a different perspective.

The purpose of Q6 as a Q7 current limiter is to make the AC impedance of Q7 so high that it does not introduce any significant AC nonlinearity. This permits the next 4(?) stages of NPN/PNP Emitter Followers to buffer the AC load impedance scaled by each hFE.  

 This results in very high Voltage AC open loop voltage gain followed by very high current gain.  The output is then fed back to an R divider thru R16 to regulate the closed loop gain.
 
The DC tolerance and stability of the DC current is not critical thru Q7 but since Ib of Q6 < 100uA the voltage, it's Vbe will be well under 0.6V but V(R18) closer to 0.6V and thus 0.6V/68Ω = 8.8mA but this could easily be +/- 25% with temp and tolerances and not affect the AC loop current gain of Q6*Q7 that regulates the constant AC current. 

 The DC current is not so constant, and drifts with temperature on Vbe but doesn't matter as much.  So I called Q6 *a soft current limiter* (for DC), but **its real purpose is to eliminate AC current load** on the hidden collector below Q8-e and thus very high open loop gain, at any desired value of DC current selected by 0.6V/R18. 

The advantage of this method is high PSRR and high linearity with no AC current out of Q7-C (other than the Early Effect current (~1 uA) for a Common Emitter (CE) amplifier. It is also insensitive to hFE for Q7/8.

When CE amplifiers are used as voltage amplifiers the AC current on the collector must be held constant to the desired tolerance for THD high quality <0.1%.