Please note: although this question involves a Raspberry Pi (hereafter RPi), it is really a pure electronics question at heart!

I am trying to connect my RPi 1 Model A to a breadboard with a single, simple on-off-on-off switch on it. The kicker here is that although I'm using an on-off-on-off switch, I really just want it to function like a normal (on-off) switch. That is: push it once, the circuit is closed and sending an input signal on to my RPi. Push it again, and the circuit open. Rinse and repeat.

I was given this diagram to follow for wiring things up:

I then subsequently inferred my own rendition of this, which more clearly shows the joining of the switch's left and right pins together (giving it the desired on-off behavior) as well as how to wire the 3.3V power on the RPi to the GPIO input pin:

So to behin with if anything above looks incorrect or awry to you, please begin by correcting me!

Assuming I'm on track, I'm now trying to actually wire this up in real life, between my RPi and my breadboard. Here's my best attempt:

Nevermind the LED and resistors in the bottom right corner of the breadboard, they're leftover from another experiment and aren't connected to anything else.

• So at the top-left we have the 3.3V power source from the RPi connected to the top-most rail on the breadboard via a red jumper; then
• A smaller red jumper wire forwards the power onto a column that is then connected to a 10-kOhm resistor; more on this in a second

On the left-side of the above photo we have the switch, here's a better look at the wiring/setup:

• Notice the small orange jumper connecting the left and right switch pins; I believe this is what accomplishes the on-off-on-off -> on-off behavior I'm looking for
• The same column that joins left and right pins (via orange jumper) is also connected to a red jumper which is also connected to the same 10-kOhm resistor we talked about up above
• Finally, the switch's middle pin is connected to the GND rail via a black jumper

This brings us to the center of the beadboard, where that big fat 10-kOhm resistor is hanging out:

• The resistor is connecting the RPi's power to the switch (both pins at the same time)
• The resistor is also connecting back to the GPIO's input pin via gray jumper wire

Finally, my question!

Remember, at the end of the day, all I want to do is:

• Convert this on-off-on-off switch to a on-off switch
• When the user presses the switch (closing it), an appropriate signal is sent on to the GPIO input pin, which is then handled at the software layer

So I ask: will my circuit accomplish the following behavior? Is it wired correctly (correct junctions of wires, correct usage of resistor, etc.)? Or will it "fry my pi"?! If anything is incorrect, what's the fix/solution?