I'd like to solder several flex wires (not solid wires) of a cable (max. 18 VDC) to a PCB. Now I've got corresponding THT holes (⌀ 0.8 mm; it's the eight holes underneath the yellow wire), but the wire is thicker (⌀ 1.1 mm). What makes my issue more complicated, is that the board is to be part of an automotive electronics solution, which must withstand slight shocks. See the picture below:

[![PCB with wires][1]][1]

So, what is a good method to solder these wires durably to the PCB?

  [1]: https://i.sstatic.net/k6Mab.jpg