Good day everyone!

I'm currently working on a project of a testing module that requires three Ethernet Ports One for network connection Two for external harware (one of which is a device being tested)

The testing module uses AM3352 SOM as a main controller and supports two MII interfaces, so i had to use W5500 (SPI interface) as a third Ethernet module instead of LAN8710A-EZC.

Question: the W5500 does not have PHYAD pins, and I am not sure if thats OK for my project... Is there a way to set physical address for this device, does it need that at all? Or do i have to use external PHY device to connect to W5500?