I recently started studying STM32 microcontrollers (BluePill STM32F103 dev board + ST-link V2 clone). I was wondering if it is possible to add serial communication to ST-Link clone?

From what I understood, those clones are copied form ST-link schematic of official Nucleo boards. The ST-link on Nucleo boards is build with STM32F103CBT6 and pins 12 and 13 (PA_2 and PA_3) are used as TX and RX for serial communication with target microcontroller (and connects to PA_2 and PA_3 pins of targer). See [page 65 of official Nucleo documentation][1]

Meanwhile, on ST-link clones those pins are floating and not connected to anything

 [![St-Link clone which I have][2]][2]

If I solder 2 wires to pins 12 and 13 of STM32 microcontroller on ST-link clone, would I be able to use those for serial communication with target microcontroller on BluePill board (PA_10 and PA_9 or PA_2 and PA_3)?


  [1]: https://www.st.com/content/ccc/resource/technical/document/user_manual/98/2e/fa/4b/e0/82/43/b7/DM00105823.pdf/files/DM00105823.pdf/jcr:content/translations/en.DM00105823.pdf
  [2]: https://i.sstatic.net/ud9vB.png