New answers tagged dac
0
votes
Accepted
How do I produce an analog output from an Arduino Mega and connect it to a PLC's analog input card? PWM and LM6211 Op-amp or arduino module?
simulate this circuit – Schematic created using CircuitLab
You can implement a PWM driven constant current sink like this. That allows you to communicate your measured signal mapped from 0-100% ...
- 1,575
0
votes
Accepted
Completed Daisy Seed Guitar Pedal
This thread did not get any answer, and I am not sure if the reason is because of lack of interest, or simply because this circuit is fine and will work.
I talked to a colleague who is savvy with ...
- 37
2
votes
Can you sum demodulated signals with a single summing amp, or is it best to demodulate individually then sum together?
If all the circuits are linear, then there is no conceptual difference.
There is a big difference in the circuits you have drawn, which is at the level of an oversight or mistake. The lowpass ...
- 171k
0
votes
BQ25570 setting different overvoltage, battery ok and MPPT levels
You could use relays to short or switch the megaohm resistors.
In the picture below the resistance between the bq25570 and node A can be switched between 1 and 2 Megaohms. You may want to limit the ...
0
votes
Attenuating mid-supply biased audio signal before AC coupled audio amplifier
To answer your question : yes there is.
First, if there is significant DC on the volume, when you change the volume quickly, the DC component will also change quickly and this can be enough to produce ...
- 7,568
0
votes
Accepted
DAC used as multiplier
The parameter you are interested in is specified in table 5V AC/DC CHARACTERISTICS of the MCP4921/4922 datasheet. There are two bandwidth rows, indicating values of 450 KHz and 400 KHz.
TL;DR
Of ...
- 4,457
1
vote
i2S DAC output and Speaker signals
The output is a class D amplifier (H-bridge) so there will be a positive or negative average (over many switching cycles) voltage across the speakers. The longer term average (over many milliseconds) ...
2
votes
i2S DAC output and Speaker signals
The link is not to a module but to a chip data sheet. And it does give that information. It's a D-class amplifier chip. Technically, it cannot give out negative voltage which you asked - but that is ...
- 164k
1
vote
Accepted
ADC/DAC system clock frequency for sampling rate
The table 3 is clear. Use any of the system clocks that make up the 48 kHz sampling rate.
The higher system clock you use will still divide automatically down to oversampling mode that allows for the ...
- 164k
Top 50 recent answers are included