New answers tagged low-pass
1
vote
Filtering out high frequency from my input graph
This can be done in software. The modulated signal can trigger an interrupt where you (re-)start a one shot timer. Set the timeout period to 70 µs. The timeout will happen only if the 16 kHz pulses do ...
- 1,859
1
vote
Accepted
Resistive current sensor shows reading when I connect it in series with a battery while no current is flowing through it
The shunt used only generates 375uV. This is not ultra low, but precautions are required.
Common Mode Rejection Ratio:
The INA219 has a typical CMRR of 120dB. Hence by moving the sense point to the ...
- 515
0
votes
Resistive current sensor shows reading when I connect it in series with a battery while no current is flowing through it
You wrote: " I did the same with a multimeter and a reading of 0.0003 mV was obtained across the shunt, which is also negligible."
Can you really measure 300nV ? An ordinary multimeter can ...
Top 50 recent answers are included