user4574's user avatar
user4574's user avatar
user4574's user avatar
user4574
  • Member for 7 years, 8 months
  • Last seen this week
3 votes
2 answers
982 views

Cortex M7 goes to HardFault immediately after reset

3 votes
1 answer
213 views

What is the longest lasting (number of years or cycles) commercially available battery technology?

2 votes
1 answer
354 views

What is the fastest (in clock cycles) 16-bit x 16-bit unsigned integer division algorithm that will run on an ATMEGA1284?

2 votes
0 answers
512 views

Are there any discrete ideal diode circuits that can operate from 6V to 130V with less than 0.5V drop @6A?

2 votes
2 answers
276 views

Why won't zones flood into vias or other plated through holes that are part of a footprint in Ki-CAD

2 votes
3 answers
545 views

What is the best way to balance supercapacitor cells at 700mA peak charging current

2 votes
1 answer
88 views

Is it possible to manufactrure a stencil for this paste-mask using the usual stencil making methods?

2 votes
0 answers
2k views

How to sell excess electronic components for highest price with least effort [closed]

2 votes
2 answers
111 views

Is there something like a banana plug that will fit in a 30mil or 50mil through hole test point?

1 vote
0 answers
573 views

What is the industry standard reference designator prefix for a PCB mount EMI shield

1 vote
1 answer
237 views

Decoupling capacitors on opposite side of board when using PCB mount EMI shield

1 vote
1 answer
260 views

Why does the AVR Assembler linker think my data table is at the wrong address?

1 vote
0 answers
35 views

How to connect switches to PWB on IP69K sealed pannel without wiring harnesses while still allowing easy separation of board and panel?

0 votes
1 answer
459 views

Can a PoE type Gigabit Ethernet Transformer be used in a non PoE application?

0 votes
3 answers
157 views

How to make sensor input look like high impedance on loss of 5V power?

0 votes
0 answers
160 views

Smallest lowest cost way to isolate RGMII signals between devices on the same CCA?

0 votes
1 answer
151 views

Will RGMII work with a small constant delay in the range of 10~20ns on all signals?

0 votes
0 answers
316 views

Is there a way in Mentor Graphics (Siemens) Pads Designer VX2.2 / Pads PCB to route through unused pads without generating a DRC error?

0 votes
1 answer
36 views

How to maximize charging power to an external battery at the lowest cost

0 votes
2 answers
174 views

What method can be used to solder a small SMD radio module to a PCB without a reflow oven

0 votes
1 answer
220 views

Whats the cheapest protection circuit for this test equipment?

0 votes
1 answer
82 views

Does anyone know the physical dimensions of the Microchip PICkit4 programmer?