K.Mulier's user avatar
K.Mulier's user avatar
K.Mulier's user avatar
K.Mulier
  • Member for 7 years, 10 months
  • Last seen more than a week ago
42 votes
10 answers
11k views

Do dead weight 'components' exist?

32 votes
6 answers
7k views

SMD soldering: tiny components stick to tweezer point

26 votes
5 answers
15k views

What exactly happens to the signals hitting a common mode choke?

12 votes
4 answers
3k views

Why exactly is it discouraged to gap the ground plane?

12 votes
3 answers
880 views

How to minimize impedance from capacitor to Gnd and Power planes

11 votes
4 answers
15k views

Best solder wire - Sn63Pb37 vs Sn60Pb40 vs ...?

9 votes
5 answers
9k views

How much can I overcharge a 4.35V LiPo?

9 votes
2 answers
6k views

SWDAP vs CMSIS-DAP vs DAPLink

8 votes
3 answers
11k views

Floating voltage-controlled resistor with LM13700: How does it work?

8 votes
1 answer
1k views

Closing loops or not? - supply lines on a PCB

7 votes
1 answer
916 views

The curse of the ground loop

6 votes
3 answers
5k views

Current distribution for parallel zeners

5 votes
1 answer
2k views

Power stage for VCR (Voltage Controlled Resistor)

4 votes
2 answers
3k views

Bismuth or Indium solder - how do they compare?

4 votes
2 answers
7k views

adjacent trace capacitance (horizontal)

3 votes
1 answer
338 views

Can the ADS1118 ADC converter accurately read a voltage close to GND?

2 votes
1 answer
830 views

Start firmware with blackmagic probe after flashing

2 votes
1 answer
1k views

Separate GND-plane for microcontroller crystal resonator

2 votes
1 answer
2k views

How to add manufacturer and supplier part numbers to components in Eagle?

2 votes
1 answer
2k views

Should I spray some flux on my board before putting it in the reflow oven?

1 vote
1 answer
93 views

Tips for fine pitch and rugged connector [closed]

1 vote
2 answers
503 views

AD7616 REFCAP pin doesn't output 4V

1 vote
1 answer
433 views

What should be done with the JTAG TRST pin when target chip has only one RESET?

1 vote
1 answer
988 views

Can't get Flyswatter2 probe to work with OpenOCD

1 vote
1 answer
713 views

How to update the SWDAP firmware?

1 vote
2 answers
2k views

DAPLink firmware doesn't operate with OpenOCD

1 vote
1 answer
3k views

High voltage linear regulator (with pre-regulator)

1 vote
2 answers
650 views

PA92 OPAMP phase compensation

0 votes
2 answers
494 views

Confusion over J-Link pinout

0 votes
1 answer
974 views

Quick jump from component in Schematic to Layout in Eagle