Linkyyy's user avatar
Linkyyy's user avatar
Linkyyy's user avatar
Linkyyy
  • Member for 7 years, 9 months
  • Last seen this week
10 votes
Accepted

Why are all the MOSFETs' drains connected together and to nowhere else?

9 votes

Why are coils of wire used in heating vs a straight wire?

8 votes

How can I convert PSpice model into LTSpice Model?

6 votes
Accepted

Do I need a heatsink for a MOSFET

4 votes

Where is the flash memory on the NodeMCU ESP8266 v3?

2 votes

PSpice circuit simulation does not seem to be working and I'm not sure why

2 votes
Accepted

Training Kit for SMD components

2 votes
Accepted

Impedance-matched antenna with an extra capacitor

2 votes
Accepted

ERROR(ORPSIM-16492)

2 votes

How does this simple FM slope detector work?

1 vote
Accepted

K_linear part description in Pspice

1 vote
Accepted

OrCAD: Determining which trace in Secondary Sweep is which after simulating

1 vote
Accepted

PSpice OrCAD simulation

1 vote
Accepted

Cosimulation Error on Advanced Design System

1 vote

Bandwidth-Noise-SNR relationship

1 vote

Stored Li-ion battery voltage going up

1 vote
Accepted

Why does AC/Sweep in Cadence always require a starting and stopping frequency?

1 vote
Accepted

Is Cadence unable to simulate AC to DC converters using simple full bridge rectifier?

1 vote

The output of a boost converter doesn't stay at 5 V

1 vote
Accepted

How to read high impedance on pin Arduino?

1 vote

Identification electronic component

1 vote

Why is the 240VAC-12VDC giving both 12VDC and 26VAC as output?

1 vote

ADS Simulation of Half-Wave Rectifier

0 votes
Accepted

How can i find the ESR of a capacitor using datasheets?

0 votes

Integrator (Op amp) Simulation OrCAD

0 votes
Accepted

MOSFET Differential Amplifier voltages via PSpice and by hand

0 votes
Accepted

Orcad Capture CIS, How to change transistor area?